| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which IP address and wildcard mask would you use in your
ACL to block all the
hosts in the subnet 192.168.16.43/28? | Siemens | 2 |
| Identify the command to display all the valid commands at the
given mode?
A.) Help all
B.) Help
C.) All commands
D.) ? | | 2 |
| Identify the 3 pieces of hardware you would not install to
prevent
broadcasts?
A.) Switch
B.) Repeater
C.) Bridge
D.) Router | | 1 |
| Which statement is true?
A. While bridges are used to segment networks, they will not
isolate broadcast or multicast packets.
B. A bridge looks at every packet within its network segment
and works like a hub re-broadcasting the packet if the
destination is within its network segment.
C. A bridge maintains a table of the IP addresses of the
hosts within its network segment and forwards the packet
directly to the destination based upon the IP address.
D. A bridge resets the hop count by keeping all packets
within the network segment. Only packets addressed to a
specific destination host outside the network segment are
allowed to pass through the bridge. | | 1 |
| Which commands will restart the router?
A.) router#system exit
B.) router >reload
C.) router#shutdown
D.) router#reload
E.) router#(config)reload
F.) router#system restart | | 6 |
| When you cords an IP address on a place router which command
stale the IP processing on the interface?
A. ip enable
B. network ip-address
C. ip address ip-address subnet mask
D. the exit command from the enabled configuration
E. copy running-configuration to startup-configuration | | 3 |
| What’s the default CDP holdtime in seconds for Cisco routers?
| | 2 |
| Which router command allows you to determine if an IP access
list is enabled on a particular interface?
A. Router# show ip interface
B. Router> show access-list
C. Router# show ip access-list
D. Router> show interface ip access-list
E. Route 1 P.O. box 198 | | 2 |
| Identify the command to configure a description on an interface?
A.) Router> description Finance department
B.) Router(config)# description Finance department
C.) Router(config-if)# description Finance department
D.) Router# description Finance department | | 1 |
| Which ISDN specification deals with call Setup and Teardown?
A.) Q-Series
B.) J-Series
C.) I- Series
D.) C- Series
E.) F-Series | | 1 |
| The administrator of a comapny needs to ensure that a web
server in
their network is accessible from the Internet. Since the
network uses private
addressing, this requires an IP-to-registered-address
mapping. The following
command is entered on the router:
router(config)# ip nat inside source static 192.168.2.1
198.18.1.254
After unsuccessful results from a ping to the Internet, the
administrator issues the
show ip nat translations command and the output is blank.
What could be the
problem with the NAT configuration for this mapping?
A. The keyword overload is missing from the command.
B. The administrator needs to define a NAT pool first.
C. An access list must be defined to create static NAT
translations.
D. The interfaces need to be configured for NAT. | | 4 |
| What does the acronym ARP stand for?
A.) Address Resolution Phase
B.) ARP Resolution Protocol
C.) Address Resolution Protocol
D.) Address Recall Protocol | | 2 |
| Identify the IPX standard access-list number range?
A.) 600 - 699
B.) 1000 - 1099
C.) 1 - 99
D.) 100 - 199
E.) 800 - 899 | | 1 |
| After the command -- router igrp 200 -- what command would
enable
IGRP on the router for interface E0, with an address of
157.89.4.4 and a
mask of 255.255.255.0 ?
A.) network 157.89.4.0 255.255.255.1
B.) network 157.89.0.0
C.) router igrp *
D.) router igrp 157.89.0.1
E.) router igrp int e1
F.) router igrp 157.89.4.1 | | 2 |
| What is the 5-4-3-2-1 rule of network design? | | 3 |
| What are the two most common request/reply pair with ICMP
messages when using the ping command? (Choose two)
A. echo reply
B. echo request
C. source quench
D. fragment onset
E. information redirect
F. destination reachable
G. echo control message | | 1 |
| Which layer is responsible for determining if sufficient
resources
for the
intended communication exists?
A.) Application
B.) Network
C.) Session
D.) Presentation
E.) Transport | | 2 |
| Identify the command that displays the SAP table?
A.) show ipx servers
B.) display SAP table
C.) display SAP's
D.) show sap table | | 1 |
| Identify 3 characteristics regarding IP access-lists?
A.) Can be configured as a standard access-list
B.) Can be run from another router running IP
C.) Can be configured as a named access-list
D.) Are the same as IPX access-lists
E.) Can be configured as an extended access-list | | 1 |
| Which of the following is an example of the Network Layer?
A.) TCP
B.) IP
C.) SQL
D.) Token Ring
E.) LLC | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Did you received any Funny E-Mails from your Friends and like to share with rest of our friends? Yeah!! you can post that stuff 
Site Map
