what is the difference between indoor package substation
and outdoor
Answers were Sorted based on User's Feedback
Answer / santosh kumar singh
basically the difference is in there cooling system,voltage
level and core material.
the core of power transformer is made up CRGO where as the
core of distribution transformer is made up of silicon steel.
generally the voltage level of power transformer is above
33kv and for this we use ONAF COOLING means we suppliment it
from fan for cooling and in distribution transformer
radiator is sufficient for cooling.
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / gopalakrishnan.s
WE HAVE INDOOR TRANSFORMER PLS SUGGEST IF WE PUT
THIS TRANSFORMER IN OUT SIDE SHELL WE ANY PROBLEM
WITHOUT SWITCHGEAR PLS I AM SEEKING YOUR VALUABLE
REPLY
Is This Answer Correct ? | 4 Yes | 4 No |
Answer / abishekmittal
As per my knowledge, Indoor package substation refers to
GIS (Gas Insulated Switchgear) substation whereas in
outdoos substation we go for AIS (Air insulated
switchgear/circuit breakers). Also, GIS substation is much
more compact as compared to AIS/Otdoor substation.
Is This Answer Correct ? | 6 Yes | 12 No |
what's float charger and boost charger? why it's used?
2 Answers APCPDCL, PTCL, Rolls Royce, Siemens,
what is reverse power relay brief explanation and in b/w where it is connected
During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct
What is the formula of frequency ?
1.Can anybody explain Why starters are not used for motor starting in industries? 2.
What is dc induction motor ? and how to control its speed ?
Why diversity factor are applied to the load?
Why screen of the screened cable not earthed on both the ends of cable
in a induction motor if we put capacitor across it will the power factor of the motor will improve? if yes how
HOw can we calculate power factor at HT side.
What is the acessaries distribution transformer ?
Why have to use copper cable for local isolator to motor ?