Classify the different types of load.
Answers were Sorted based on User's Feedback
Answer / abdulsubur
REACTIVE LOAD INDUCTIVE LOAD CAPACITIVE LOAD
Is This Answer Correct ? | 24 Yes | 9 No |
Answer / subash chandra bose.a
readtive load, impedance load & capactive load.
Is This Answer Correct ? | 23 Yes | 13 No |
Answer / snn murthy
resistive load,capacitive load and inductive load
Is This Answer Correct ? | 11 Yes | 5 No |
Answer / reshi
For motors the loads can be classified as:
1.Constant torque
2.Wwhere torque changes gradually
3.Where torque changed abruptly.
In generic Loads can further be defined as.
1. Static loads
2. Dynamic Loads
Static loads include :lights, heaters etc.
Dynamic loads includes: Rotating machinary
Is This Answer Correct ? | 16 Yes | 15 No |
Answer / h
Different types of load in electrical industry are:
1 Resistive
2 Inductive
3 Capacitive.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / rajeshsan
The loads can be classified as based on
1. Continuous load and intermediate load.
2. Static and Dynamic load
3. Load may be inductive or capacitive.
Is This Answer Correct ? | 4 Yes | 11 No |
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
what is buffer resistance starter.?.What is the working principle and where it is used..?
How much current can carry the 1 sq inch super enamelled copper wire?
Why starters are using the machines???
tell me about vfd
can u give me a brief idea about power line carrier communication ??
what is oti and wti
What is an order of a system.
How to check the cable fault / hv test of transformer cable.
I BOUGHT A HAVELLS ACCL WITH GENERATOR STOP FASCILITY(i.e- BASICALLY IT IS A AUTO CHANGE OVER SWITCH) FOR MY HONDA EXK 2000S HOME GENERATOR (WHICH START IN PETROL & RUN IN KEROSENE). ACCL HAS 8 POINT. 2 FOR MAINS(PH & NUE), 2 FOR LOAD, 2 FOR GEN AND 2 FOR IGNITION POINT(X1 & X2). THE IGNITION POINT IS SPECIALLY FOR AUTO ENGINE STOP WHEN MAINS POWER RESTORE. I CONNECT THIS X1 & X2 POINT TO THE GENERATOR STATER MOTOR & EARTHING POINT. BUT WHEN MAINS FAILS THE GENERATOR COULD NOT START, BUT WHEN DISCONNECT THOSE X1 OR X2 POINT, THEN THE GENERATOR START. BUT WHEN MAINS ON THEN THE GENERATOR SHOULD START, AND WHEN I OFF THE MAINS THE GENERATOR AUTOMATICALLY STOP. PLESE HELP ME HOW I STOP THE GENERATOR AUTOMATICALLY WHEN THE MAINS RESTORE.
How to determine earth fault level to set relay for a normal distribution system of 11 kV , 100 A load????????
what is solkor relay and which condition it will act?