| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which of the following is a characteristic of a switch, but
not of
a repeater?
A.) Switches forward packets based on the IPX or IP address
in the frame
B.) Switches forward packets based on the IP address in the
frame
C.) Switches forward packets based on the MAC address in the
frame
D.) Switches forward packets based only on the IP address in
the packet | | 2 |
| 8. When is Frame Tagging used?
A. When you install repeaters in your network
B. When you install bridges in your network
C. When you install routers in your network
D. When you use Switches configured with multiple VLANS
| | 4 |
| What would be the first command from global configuration
mode to
enable
RIP on your router for interface E0, with an address of
181.86.4.4 and
mask of 255.255.255.0 ?
A.) router rip
B.) network 181.89.4.0 255.255.255.0
C.) router rip int e0
D.) router rip 181.86.0.0
E.) router rip 181.86.4.0
F.) network 181.86.0.0 | | 1 |
| What are four benefits that can result from applying ISDN
networking? (Choose four)
A. Full time connectivity across the ISDN is spoofed by
Cisco IOS routers using dial on demand routing (DDR)
B. Small Once and Home Once sites can be economically
supported with ISDN Basic Rate Interface (BRI) servkps
C. ISDN replaces Signaling System 7 (SS7) in the Public
Switched Telephone Network (PSTIC) backbone
D. ISDN can be used as a backup service for a leased line
connection between the remote and central chaps
E. Modem racking and cabling can be eliminated by
integration of digital modem cards on Cisco IOS Network
Acess Servers (NAS) | | 2 |
| There is an emergency fall-back 'skeleton' IOS stored in
read only
memory on all Cisco routers. What command would make the
router load the
IOS from
Read Only Memory?
A.) reload rom
B.) boot system rom
C.) load ios bootflash
D.) load ios rom
E.) bootsystem skeleton | | 2 |
| You have an IP host address of 201.222.5.121 and a subnet
mask of 255.255.255.248. What is the broadcast address?
A. 201.222.5.127
B. 201.222.5.120
C. 201.222.5.121
D. 201.222.5.122 | | 1 |
| Identify the hardware component used to store buffers, tables,
running-configuration etc?
A.) NVRAM
B.) ROM
C.) RAM
D.) Flash | | 3 |
| How do you disable CDP on the entire Router?
A.) Router#no cdp run
B.) Router(config-if)# no cdp enable
C.) Router(config)# no cdp enable
D.) Router(config)# no cdp run | | 1 |
| Identify the command that displays the SAP table?
A.) show ipx servers
B.) display SAP table
C.) display SAP's
D.) show sap table | | 1 |
| You want to enable both arpa and snap encapsulation on one
router interface. How do you do this?
A. The interface can handle multiple encapsulation types
with no extra configuration.
B. Assign two network numbers, one for each encapsulation
type.
C. Enable Novell-ether to run multiple encapsulation types.
D. Both arpa and snap are enabled by default so you don't
have to configure anything. | | 1 |
| Identify the command that disables name-to-address translation?
A.) Router(config-dns)# no ip domain-lookup
B.) Router(config)# no address translation
C.) Router(config)# no ip domain-lookup
D.) Router(config)# ip domain-lookup | | 1 |
| Identify the command to copy a configuration file from a TFTP
server to a routers active configuration?
A.) Router# copy running-config tftp
B.) Router# copy tftp running-config
C.) Router# copy tftp 172.16.0.1 running-config
D.) Router(config)# copy tftp running-config | | 1 |
| As a system administrator, you need to provide your routers
with a Domain Name System (DNS) server. How many DNS
servers can you specify with one command?
A. 6
B. 1
C. 2
D. 4 | | 1 |
| What are two purposes for segmenting a network with a
bridge? (Choose two)
A. to reduce collisions
B. to increase collisions
C. to add collision domains
D. to reduce collision domains
E. to have more broadcast domains | | 1 |
| Write out a config to permit only the below MAC address
to pass traffic through a port on your switch.
mac-address 0005.1b00.5b58 | | 4 |
| Why Clock rate command is not configured on ethernet
interface of a router? | | 4 |
| Identify 3 IP applications?
A.) AURP
B.) ARP
C.) Telnet
D.) SMTP
E.) DNS
F.) RARP | | 2 |
| Which of the following is not a characteristic of link-state
routing protocols?
❍ A. VLSM support
❍ B. Route summarization at any bit level
❍ C. Full routing updates at regular intervals
❍ D. Discontiguous network support | | 1 |
| Request any body to explain the parameters of Ipsec vpn
tunnel while creating a tunnel in Cisco ASA. | HCL | 3 |
| Identify the command to configure ALL the default VTY ports?
A.) Router(config)# line vty 0 4
B.) Router# line vty 0 4
C.) Router(config)# line vty
D.) Router(config)# line vty 0 | Accel | 2 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
