| Other Electrical Engineering Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| how vfd drives energy save | PowerTech | 2 |
| what is skin effect? why is it absentin dc system | | 10 |
| how calculate gd2 of ht motors | Hindustan-Copper-Limited | 1 |
| In a Circuit how the MCB and Fuse ratings are calculated.
And shall the fuse follws the MCB or it is otherwise? | Emerson | 2 |
| In Ferranti effect,Receiving end voltage is greater than
sending voltage,why? can anybody tell me the answer | | 5 |
| How to increase the specific gravity of DG batteries? | SCS | 2 |
| if we convert kw into kva,which one formula use by us,pls
tell me? | ABB | 5 |
| what is active network? | | 1 |
| Is your generator is automated or manual if so do you know
the circuits? | RRB | 1 |
| difference between elcb and rccb | ITC-Infotech | 2 |
| What is the difference between short circuit and overload
currents? | | 4 |
| What is an infinite bus bar? | | 3 |
| power is the product of voltage and current.so we can
measure the value of power just by using ammeter and
voltmeter.......then why do we use a wattmeter? | | 1 |
| why the auxilary(starting)winding is provided in single
phase inductoin motor? | | 2 |
| In view of Electrical Engg. What is the use of SCR(Silicon
control rectifier) | | 4 |
| We have 800KW motor operating at 6600Volt,50 Hz
supply.During 1st startup it tripped on overcurrent
trip.It's FLA is 88 Amps.The K factor of Thermal overloaaad
was set on .94 initially.then we set at 0.97 and then it
started fine.i dont understand why it tripped first?What
are the protections which comes in picture during starting ? | | 3 |
| how to connect from a line-to-line connection to a line-to-
neutral connection? | | 3 |
| what is the difference between the diode and the rectifier | Avalon | 3 |
| What is the meaning of maximum demand | | 9 |
| What differance between Circuit brekar and Isolater? | TATA | 9 |
| |
| For more Electrical Engineering Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
