| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| To prevent Service Advertisements (SAPs) from flooding a
network, Cisco routers do not forward them. How are
services advertised to other networks?
A. Each router builds its own SAP table and forwards that
every 60 seconds.
B. Each router assigns a service number and broadcasts
that.
C. SAPs aren't necessary with Cisco routers.
D. Cisco routers filter out all SAPs. | | 1 |
| Identify the statement which connects access-list 101 inbound to
interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in | | 1 |
| Identify the access-list range for an extended IP access-list?
A.) 800 - 899
B.) 1 - 99
C.) 1000 - 1099
D.) 100 - 199 | | 4 |
| Routers that have Flash memory typically have a ore loaded
copy of place IOS software. Which command should you use to
make a backup copy of the software image onto a given
network server?
A. copy flash tftp
B. save copy to tftp
C. write backup tftp
D. write, backup -server-name-
E. copy backup to -server-name- | | 1 |
| Which command should you use to confound a router so that it
can become a TFTP server host for a router system image that
is run in a Flash?
A. copy flash tftp
B. config tftp server
C. write, network -router name-
D. tftp-server system -file name-
E. setup server tftp -system name- | | 1 |
| Identify the definition of demarcation?
A.) Date in which the WAN service contract expires
B.) Cabling which extends from the WAN service provider to
the customer
C.) Division of responsibility, where the CPE ends and the
local loop
begins
D.) Equipment which is located at the customer premises | | 1 |
| Which service takes information from multiple sources and
allocates bandwidth on a single media?
A. Time-division Multiplexing (TDM)
B. Signaling System 7 (SS7)
C. X.25
D. Frame relay | | 1 |
| What is the bandwidth capacity of one ISDN B channel
A. 64 kbps
B. 128 kbps
C. 512 kbps
D. 1.54 mkbps | | 3 |
| What does a router change in a packet when it forwards a
packet to the next hop?
* A: Destination physical address
* B: Destination network address
* C: Destination network address and the destination
physical address
| Microland | 7 |
| What is the default size of a standard ping on a Cisco router?
* A: 100 bytes
* B: 32 bytes
* C: 10 bytes
* D: 16 bytes
| CMS | 2 |
| What is a characteristic of Store and Forward switches?
A.) They work at wire speed.
B.) They are the same as Cut-Through switching in 'prune' mode.
C.) They forward based on transport layer info.
D.) They forward the frame before it is completely read.
E.) They increase latency. | | 1 |
| what is difference between
1 pap and chap(quite easy but need on line answer)
2 chap and ms-chap(plz describe briefly)
now i have posted the question is there any one to help me?
| | 1 |
| what hapeen we we configure default root on the router
which is conected by isp
supoese there are two router r1 is conected throug isp and
and by s0 r1 is conexted to r2
if we apply degault root on r1 what will happen | | 3 |
| What’s the default CDP holdtime in seconds for Cisco routers?
| | 2 |
| Identify the command mode necessary to enter the extended ping
command?
A.) Router#
B.) Router>
C.) Router(config)#
D.) Router(ext-ping)# | | 1 |
| ok this is practical senario question
how can we comunicate two diffrent network host by i single
1603 sires of cisco router rember that the cisco series of
that router have singe 100mbps ethernet
now think think
write all command
answer is so simple i wiil; give the answer after 20 visit
til then wait
| | 2 |
| As the system administrator, you type "ppp authentication
chap pap
secret". Which authentication method is used first in
setting up a session?
A. secret
B. PAP
C. CHAP
D. PPP/SLIP | | 1 |
| What is the maximum hop count for IP RIP?
A.) Infinity
B.) 16
C.) 15
D.) 1 | Cisco | 2 |
| You need to come up with a TCP/IP addressing scheme for your
company. How
many network IDs must you allow for when you define the
subnet mask for
the network?
A.) One for each WAN link
B.) One for each router interface
C.) One for each NIC installed in each client
D.) One for each subnet with hosts
E.) One for each host ID | | 1 |
| what is the distance betwwen link stae routing protocl and
distance vector
who have the best convergence toplogy
eigrp conatain 3 table name them
what the toplogy table contain | IBM | 5 |
| |
| For more CCNA Interview Questions Click Here |
Did you received any Funny E-Mails from your Friends and like to share with rest of our friends? Yeah!! you can post that stuff 
Site Map
