| Other Electrical Engineering Interview Questions |
|| Asked @
|What happens if you give supply to the rotor of three phase
|Why is shaft current insulation required on large motors &
when should it be checked i.e. before or after assembly?
|How open delta used for protection?
|Can I parallel 1 MVA generator with 1kVA Generator? if V, F,
Ph Seq and Ph angles are same
|Is only insulation the difference between High voltage and Medium voltage cable?
|from 33kv to 440v 2mva transformer how much full load
current will be at ht side and lt side and which range of
ctpt will be used?
|In APFC panel, Why on dealy timer is used in Capacitor
|How much KVAr bank reqired for 630 KVA transformer on full
load for maintain power factor upto.99
|when voltage gets down the current of motor increases. but
according to Ohm's law voltage is directly proportional to
current. plz explain
|3-PHASE 15KVA dg IS EQUIVALENT TO 12 KW,hOW?
|Wy transformer ratings are in multiple of 11 always?
|Hello friends., my question is related to testing of current
transformer... A Ct having knee point voltage of 750 volts.,
and I have two step up transformer's of rating 230 v to
440 volts., can I obtain the value of 750 volts by using the
two transformer's.... If yes then how could I connect the
transformer's to obtain knee point voltage?? thank you in
|For more Electrical Engineering Interview Questions Click Here |