| Other Electrical Engineering Interview Questions |
|| Asked @
|why we are used thermistor in motor
|What should be the earth pit resistance value?
|1)how many types of earth? 2)how many types of megger and how
to select that range? how much time taken for megger
calibration( we r using megger)
|what is transformer
|how to calculate Amp, 2 different Amp of batteries?
No. of Batteries = 2
Battery voltage = 12V
1st Battery rating = 17AH
2nd battery rating = 30AH
between parallel connection then output volt
|what is the operation of Control Module(CM),MONITOR
Module(MM), MONITOR Module DUAL (MM2),Signal
Module(SM),Isolator Module(IM), please some one reply me..
the operation and application of these in FIRE ALARM SYSTEMS...
|How can we measure and monitor critical performance
parameters of Diesel Generator Sets, both electrical and
|Types of 132KV and 222 KV protection.
|Why the steam turbines are run at high speed where as the
hydro turbines are run at low speed?
|2 Diesel Generators 900KVA connected to the bus bar for
essential load as an alternative for power taken from
11/440V 3KVA Transformer supplying this bus bar. my
question here is in the event of power failure on 11KV side
can I feed the power to 11 KV bus by using the same
transformer as reverse feed, what will be the inrush
|how i prepare for the written test in mahagenco?
|what is allowable current flows from phase to ground with
out tripping the breaker
|For more Electrical Engineering Interview Questions Click Here |