| Other CCDA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What set of Frame Relay enhancements offer extensions for
managing complex internetworks?
A. CMT
B. SNMP
C. LMI
D. RMON | | 1 |
| What are the five areas of the ISO Network Management Model?
A. Performance management
B. Accounting management
C. Flow management
D. Configuration management
E. Operating management
F. Fault management
G. Routing management
H. Security management | | 1 |
| Which of the following three sets of IP addresses and subnet
masks are private IP addresses?
A. 10.0.0.0 255.0.0.0
B. 172.16.0.0 255.255.0.0
C. 172.16.0.0 255.240.0.0
D. 192.168.0.0 255.255.0.0 | | 1 |
| What are metrics used with IGRP?
A. Ticks
B. Load
C. Hops
D. Delay | | 1 |
| What should be looked at first to determine if a customer
should switch from a hub environment to a switched environment?
A. Investigate the number of broadcasts
B. Investigate the number of collisions
C. Determine what routing loops are present
D. Determine which switching type is being used by the hubs | | 1 |
| What is the standard ethernet cabling specification? (not
IEEE 802.3)
A. STP
B. Coax (thin)
C. Coax (thick)
D. UTP | | 1 |
| Traffic Shaping does which one of the following?
A. Eliminates bottlenecks by throttling back traffic volume
at the source or outbound end
B. Reduces the frame size so bandwidth is better utilized
C. It increases source traffic to a configured bit rate
D. Allows you to control hubs and repeaters | | 1 |
| What network design is becoming common when there is a
central office with one or more remote locations?
A. ISDN PRI at the central location and ISDN BRI at the
remote locations.
B. Using core routers at all sites
C. Only using access routers
D. Using a full mesh network | | 1 |
| What is the technique used by a router that can
automatically initiate and close a circuit-switched session?
A. PLP
B. LAPP
C. ASN.1
D. DDR | | 1 |
| When characterizing a network, how many buffer misses should
not be exceeded on a Cisco router per hour?
A. 10
B. 25
C. 50
D. 100 | | 1 |
| Which Of the Statements best describes VPLS ?
| Pari-Networks | 1 |
| How does the Spanning Tree Protocol (STP) prevent bridging
loops?
A. By not allowing any redundant paths within the network
B. By calculating the metrics of each path
C. By detecting and logically blocking redundant paths from
the network
D. By creating virtual LANS | HCL | 1 |
| Which router would you choose for your design?
A. 1600
B. 1700
C. 3600
D. 3640
E. 7200 | | 1 |
| Which address is updated at each hop in the path in path
switching? | | 1 |
| You may receive a case study including Token Ring and
Ethernet, so you may want to look at any constraints with
cabling between Token Ring and Ethernet networks.
Which statement describes the constraints imposed by the
existing network?
A. Replace all cabling
B. Test all cabling
C. Do not replace cabling
D. Use microwave instead of cabling | | 1 |
| What category or categories does Client/Server fit into the
following Job Aid?
Name of Protocol Type of Protocol # of Users # of Hosts or
Servers Comments | | 1 |
| 5. Which Two Settings must be configured in order to use the
GUI to configure Call Admission Control with voice Applications
| Pari-Networks | 1 |
| Which two statements correctly identify considerations to
take into account when deciding on campus QoS Design elements ? | Pari-Networks | 1 |
| Distance Vector and Link-State protocols converge more
quickly if:
A. there is router redundancy
B. there is router redistribution
C. the update interval is set to its maximum
D. the whole routing table is sent to announce changes | | 1 |
| What device initiates a session in an X.25 network?
A. DTE
B. DCE
C. PSE
D. PAD | | 1 |
| |
| For more CCDA Interview Questions Click Here |
To Refer this Site to Your Friends 
Site Map
