| Other CCDA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| 5. Which Two Settings must be configured in order to use the
GUI to configure Call Admission Control with voice Applications
| Pari-Networks | 1 |
| What happens when the hold-down timer expires?
A. Routes are flushed from the routing table after the flush
timer expires
B. Routes are flushed from the routing table immediately
C. Routes are never flushed
D. A triggered update will reset the hold-down timer | | 1 |
| What PPP frame initiates the network layer protocols to be
used during a connection? | | 1 |
| What is the first step in diagramming packet flow for the
terminals within a network?
A. Identify the end user nodes of all the terminals
B. Figure out the speed of all the servers
C. Find out where all the routers are located
D. Find out where all the switched are located | | 2 |
| What set of Frame Relay enhancements offer extensions for
managing complex internetworks?
A. CMT
B. SNMP
C. LMI
D. RMON | | 1 |
| What would a TE2 device be used for in an ISDN connection?
A. as a connection from an NT1 device to an NT2 device
B. as a connection from a non-ISDN terminal through a TA to
the ISDN network
C. as a connection from four-wire subscriber wiring to the
conventional two-wire local loop
D. as a connection to the ISDN network through a four-wire,
twisted-pair digital link | | 1 |
| Which of the following are true regarding switched virtual
circuits (SVCs) and permanent virtual circuits (PVCs)?
Choose two.
A. SVCs and PVCs can use the same circuit.
B. PVCs are permanently established virtual circuits.
C. SVCs and PVCs terminate the circuit when data
transmission is complete.
D. SVCs are virtual circuits that are dynamically
established on demand and terminated when data transmission
is complete. | | 1 |
| What are the three commonly used methods of flow control
used for handling network congestion?
A. Buffering
B. Source-quench messages
C. Error checking
D. Windowing | | 1 |
| You may receive a case study including Token Ring and
Ethernet, so you may want to look at any constraints with
cabling between Token Ring and Ethernet networks.
Which statement describes the constraints imposed by the
existing network?
A. Replace all cabling
B. Test all cabling
C. Do not replace cabling
D. Use microwave instead of cabling | | 1 |
| What are two differences between 10BaseT and 100BaseT?
A. Speed
B. Frame format
C. Addressing
D. Network diameter | | 1 |
| Distance Vector and Link-State protocols converge more
quickly if:
A. there is router redundancy
B. there is router redistribution
C. the update interval is set to its maximum
D. the whole routing table is sent to announce changes | | 1 |
| Match the following devices with the correct description.
A. Switch 1. Operates at the physical layer and
extends the cable as if it is a single
cable.
B. Router 2. Operates at the physical layer and
connects all connections into one
device or concentrator.
C. Repeater 3. Operates at the network layer and
can filter both hardware and network
addresses.
D. Hub 4. Works at the Data-Link layer and
transmits a digital signal only to the
specific port where the destination
MAC address is located. | | 1 |
| What is an advantage of CHAP over PAP?
A. Passwords are stored on separate servers in encrypted form
B. CHAP sends passwords unencrypted to save connection time
C. CHAP does not attempt to verify whether the user is
authorized to access the requested resource
D. ID?s and passwords are automatically stored in cache | | 1 |
| Which of the following three protocols replace SDLC?
A. 802.2
B. HDLC
C. QLLC
D. X.25 | | 1 |
| What AppleTalk protocol permits AppleTalk workstations to
share files across a network? | | 1 |
| A remote user needs a static IP address to support a
specific application.Which remote access VPN addressing
technique supports this ?
| Pari-Networks | 2 |
| What is not a function of the distribution layer?
A. Routing between VLANs
B. Implement tools such as access lists, packet filtering,
and queuing
C. Implement security and network policies
D. Provide workgroup/user access to the network | | 1 |
| What address is 12 hexadecimal, resides in the Data-Link
layer, and is burned in the ROM by the manufacturer. | | 1 |
| What happens to performance if the maximum MTU (Maximum
Transmission Unit) size is used?
A. Performance increases
B. Performance decreases
C. Performance stays the same
D. Performance has nothing to do with the MTU | | 1 |
| What is the second step when creating a prototype?
A. Develop a test plan
B. Review the customer requirements
C. Investigate what the competition will be proposing
D. Define how big the prototype will be | | 1 |
| |
| For more CCDA Interview Questions Click Here |
Site Map
