| Other CCDA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What happens to performance if the maximum MTU (Maximum
Transmission Unit) size is used?
A. Performance increases
B. Performance decreases
C. Performance stays the same
D. Performance has nothing to do with the MTU | | 1 |
| What would you include in your prototype design for this
particular case study? | | 1 |
| What are two true statements regarding DDR (Dial-on-Demand
Routing)?
A. Allows a router to automatically initiate and end a
circuit-switched session
B. DDR cannot be configured because it is set with a default
configuration
C. Can configure it to be used during non-peak hours
D. Can only be used with Cisco PIX | | 1 |
| When designing a flat switched network you can have:
A. the same number of IP and IPX nodes without performance
degradation
B. more IP than IPX nodes on the same segment
C. more IPX than IP nodes on the same segment
D. more AppleTalk than IP nodes on the same segment | | 1 |
| 6. Which of these statements best describes VPLS ?
| Pari-Networks | 1 |
| What type of address is analyzed by a Layer 2 switch?
A. network address
B. MAC and network address
C. Protocol type, MAC, and network address
D. MAC address | | 2 |
| What are the three commonly used methods of flow control
used for handling network congestion?
A. Buffering
B. Source-quench messages
C. Error checking
D. Windowing | | 1 |
| What is an advantage of CHAP over PAP?
A. Passwords are stored on separate servers in encrypted form
B. CHAP sends passwords unencrypted to save connection time
C. CHAP does not attempt to verify whether the user is
authorized to access the requested resource
D. ID?s and passwords are automatically stored in cache | | 1 |
| Match the following services with the correct descriptions:
A. BRI 1. Provides two 64 Kbps B channels
B. PRI 2. Provides 23 or 30 B channels
3. Provides one 16 Kbps D channel
4. Provides one 64 Kbps D channel
5. Provides a total bit rate of 2.048 Mbps
in Europe and Australia
6. Provides a total bit rate of 144 Kbps
7. Provides a total bit rate of 1.544 Kbps
in North America and Japan | | 1 |
| Which address is updated at each hop in the path in path
switching? | | 1 |
| The following are examples of proactive network management
except:
A. Allocate sufficient staff time
B. Troubleshooting and solving system problems
C. Generate reports
D. Identify Problems | | 1 |
| Which of the following does not specify an application
requirement that affects your network design?
A. The number of users
B. The peak hours that the applications are used
C. The types of applications used
D. Security risks | | 1 |
| What set of Frame Relay enhancements offer extensions for
managing complex internetworks?
A. CMT
B. SNMP
C. LMI
D. RMON | | 1 |
| What layer of the OSI reference model does TCP reside in?
A. Session
B. Transport
C. Network
D. Data-Link | | 1 |
| A remote user needs a static IP address to support a
specific application.Which remote access VPN addressing
technique supports this ?
| Pari-Networks | 2 |
| How is data transmitted in a Token Ring network?
A. The node calls for a token, appends the data, modifies a
bit in the frame, then sends the token
B. The node waits for the token, gains possession of it,
appends the data, modifies a bit in the frame, then sends
the token
C. The node transmits the data whenever it wants to
D. The active monitor must first grant permission for the
node to transmit data. After it receives permission, it
sends the data | | 1 |
| Which of the following three sets of IP addresses and subnet
masks are private IP addresses?
A. 10.0.0.0 255.0.0.0
B. 172.16.0.0 255.255.0.0
C. 172.16.0.0 255.240.0.0
D. 192.168.0.0 255.255.0.0 | | 1 |
| ISDN is referenced by a suite of ITU-T (International
Telecommunication Union Telecommunication Standardization
Sector) standards encompassing what three layers of the OSI
reference model?
A. Physical
B. Data Link (LAPD)
C. Data Link (RMON)
D. Network (Q.930 and Q.931) | | 1 |
| Match the following devices with the correct description.
A. Switch 1. Operates at the physical layer and
extends the cable as if it is a single
cable.
B. Router 2. Operates at the physical layer and
connects all connections into one
device or concentrator.
C. Repeater 3. Operates at the network layer and
can filter both hardware and network
addresses.
D. Hub 4. Works at the Data-Link layer and
transmits a digital signal only to the
specific port where the destination
MAC address is located. | | 1 |
| Which tools help to characterize a network?
A. Sniffer
B. CiscoWorks 2000
C. Netsys
D. All of the above | | 1 |
| |
| For more CCDA Interview Questions Click Here |
Site Map
