| Other CCDA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What is the standard ethernet cabling specification? (not
IEEE 802.3)
A. STP
B. Coax (thin)
C. Coax (thick)
D. UTP | | 1 |
| What would a TE2 device be used for in an ISDN connection?
A. as a connection from an NT1 device to an NT2 device
B. as a connection from a non-ISDN terminal through a TA to
the ISDN network
C. as a connection from four-wire subscriber wiring to the
conventional two-wire local loop
D. as a connection to the ISDN network through a four-wire,
twisted-pair digital link | | 1 |
| What are two differences between 10BaseT and 100BaseT?
A. Speed
B. Frame format
C. Addressing
D. Network diameter | | 1 |
| Which condition does not create LAN media problems?
A. Protocol doesn?t scale well
B. Long wait for the token
C. Excessive collisions
D. Too many devices | | 1 |
| What happens when the hold-down timer expires?
A. Routes are flushed from the routing table after the flush
timer expires
B. Routes are flushed from the routing table immediately
C. Routes are never flushed
D. A triggered update will reset the hold-down timer | | 1 |
| Which router would you choose for your design?
A. 1600
B. 1700
C. 3600
D. 3640
E. 7200 | | 1 |
| A remote user needs a static IP address to support a
specific application.Which remote access VPN addressing
technique supports this ?
| Pari-Networks | 2 |
| What are two services that the OSPF Hello protocol provides?
A. It discovers neighbor routers
B. It gets routes from neighbors during startup
C. It helps elect a designated router
D. It allows administrator to test for connectivity between
two devices | | 1 |
| With Centralized Routing, each node must determine and
maintain its routing information independently?
A. True
B. False | | 1 |
| What are the five areas of the ISO Network Management Model?
A. Performance management
B. Accounting management
C. Flow management
D. Configuration management
E. Operating management
F. Fault management
G. Routing management
H. Security management | | 1 |
| Which of the following is not true in regards to route
summarization?
A. It increases the size of the routing table
B. It increases the complexity of the network
C. IP networks must be contiguous to be safely summarized
D. Routing tables must have the capacity to support
classless routing | | 1 |
| When should you apply SAP filters to Netware service
advertisement messages?
A. When services are not required for a particular area or
network
B. Only after service advertisement messages have flooded
the network
C. Before any type of router convergence takes place
D. When no change in network services has taken place for 40
minutes | | 1 |
| Diagramming application information flow is important because:
A. it helps identify heavy traffic paths
B. it helps figure out why email gets from one place to another
C. it can tell you when to purchase a new router
D. it can tell you when to purchase a new switch | | 2 |
| What network design is becoming common when there is a
central office with one or more remote locations?
A. ISDN PRI at the central location and ISDN BRI at the
remote locations.
B. Using core routers at all sites
C. Only using access routers
D. Using a full mesh network | | 1 |
| What is an advantage of CHAP over PAP?
A. Passwords are stored on separate servers in encrypted form
B. CHAP sends passwords unencrypted to save connection time
C. CHAP does not attempt to verify whether the user is
authorized to access the requested resource
D. ID?s and passwords are automatically stored in cache | | 1 |
| What would you include in your prototype design for this
particular case study? | | 1 |
| What should be looked at first to determine if a customer
should switch from a hub environment to a switched environment?
A. Investigate the number of broadcasts
B. Investigate the number of collisions
C. Determine what routing loops are present
D. Determine which switching type is being used by the hubs | | 1 |
| You want to assign IP addresses to a large number of
workstations. What is the best way to do this?
A. Cisco Network Registrar
B. Cisco IOS NAT Feature
C. Assign them static IP addresses
D. Let the workstation assign its own IP address | | 1 |
| Which address is updated at each hop in the path in path
switching? | | 1 |
| When designing a flat switched network you can have:
A. the same number of IP and IPX nodes without performance
degradation
B. more IP than IPX nodes on the same segment
C. more IPX than IP nodes on the same segment
D. more AppleTalk than IP nodes on the same segment | | 1 |
| |
| For more CCDA Interview Questions Click Here |
To Refer this Site to Your Friends 
Site Map
