| Other CCDA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What should be looked at first to determine if a customer
should switch from a hub environment to a switched environment?
A. Investigate the number of broadcasts
B. Investigate the number of collisions
C. Determine what routing loops are present
D. Determine which switching type is being used by the hubs | | 1 |
| What is the standard ethernet cabling specification? (not
IEEE 802.3)
A. STP
B. Coax (thin)
C. Coax (thick)
D. UTP | | 1 |
| What would you include in your prototype design for this
particular case study? | | 1 |
| Which router would you choose for your design?
A. 1600
B. 1700
C. 3600
D. 3640
E. 7200 | | 1 |
| What are two services that the OSPF Hello protocol provides?
A. It discovers neighbor routers
B. It gets routes from neighbors during startup
C. It helps elect a designated router
D. It allows administrator to test for connectivity between
two devices | | 1 |
| What are two services that DUAL (Diffusing Update Algorithm)
performs for EIGRP?
A. Provides loop-free operation throughout an entire route?s
computation
B. Simultaneous synchronization of routers involved in a
topology change
C. Updates the autonomous system number
D. Allows advertised distances to use feasible distances | | 1 |
| How is data transmitted in a Token Ring network?
A. The node calls for a token, appends the data, modifies a
bit in the frame, then sends the token
B. The node waits for the token, gains possession of it,
appends the data, modifies a bit in the frame, then sends
the token
C. The node transmits the data whenever it wants to
D. The active monitor must first grant permission for the
node to transmit data. After it receives permission, it
sends the data | | 1 |
| You may receive a case study including Token Ring and
Ethernet, so you may want to look at any constraints with
cabling between Token Ring and Ethernet networks.
Which statement describes the constraints imposed by the
existing network?
A. Replace all cabling
B. Test all cabling
C. Do not replace cabling
D. Use microwave instead of cabling | | 1 |
| What PPP frame initiates the network layer protocols to be
used during a connection? | | 1 |
| When should you apply SAP filters to Netware service
advertisement messages?
A. When services are not required for a particular area or
network
B. Only after service advertisement messages have flooded
the network
C. Before any type of router convergence takes place
D. When no change in network services has taken place for 40
minutes | | 1 |
| Which IP address is not a private address?
A. 142.18.0.0
B. 10.0.0.0
C. 172.16.0.0
D. 192.168.0.0 | NetMax | 1 |
| What category or categories does Client/Server fit into the
following Job Aid?
Name of Protocol Type of Protocol # of Users # of Hosts or
Servers Comments | | 1 |
| What set of Frame Relay enhancements offer extensions for
managing complex internetworks?
A. CMT
B. SNMP
C. LMI
D. RMON | | 1 |
| How many networks will be advertised using route
summarization within an OSPF network if you are given the
following networks?
192.108.168.0
192.108.169.0
192.108.170.0
192.108.171.0
192.108.172.0
192.108.173.0
192.108.174.0
192.108.175.0
A. 1
B. 2
C. 3
D. 4
E. 5 | | 1 |
| 5. Which Two Settings must be configured in order to use the
GUI to configure Call Admission Control with voice Applications
| Pari-Networks | 1 |
| What type of address is analyzed by a Layer 2 switch?
A. network address
B. MAC and network address
C. Protocol type, MAC, and network address
D. MAC address | | 2 |
| The following are the four steps in establishing an X.25
virtual circuit. Place them in the correct order.
A. The PSE (Packet Switch Exchange) passes the packet to the
next remote DCE
B. The local DCE packet binder sends packet to the closest
PSE (Packet Switch Exchange)
C. The source DTE sends packet to the local DCE
D. The remote DCE examines the packet header of destination DTE | | 1 |
| What AppleTalk protocol permits AppleTalk workstations to
share files across a network? | | 1 |
| Distance Vector and Link-State protocols converge more
quickly if:
A. there is router redundancy
B. there is router redistribution
C. the update interval is set to its maximum
D. the whole routing table is sent to announce changes | | 1 |
| Client traffic is being bridged trough LAN interfaces on two
WLCs.Which roaming option will Keep
them on the same IP Subnet ?
| Pari-Networks | 2 |
| |
| For more CCDA Interview Questions Click Here |