| Other CCDA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| How is data transmitted in a Token Ring network?
A. The node calls for a token, appends the data, modifies a
bit in the frame, then sends the token
B. The node waits for the token, gains possession of it,
appends the data, modifies a bit in the frame, then sends
the token
C. The node transmits the data whenever it wants to
D. The active monitor must first grant permission for the
node to transmit data. After it receives permission, it
sends the data | | 1 |
| Match the following devices with the correct description.
A. Switch 1. Operates at the physical layer and
extends the cable as if it is a single
cable.
B. Router 2. Operates at the physical layer and
connects all connections into one
device or concentrator.
C. Repeater 3. Operates at the network layer and
can filter both hardware and network
addresses.
D. Hub 4. Works at the Data-Link layer and
transmits a digital signal only to the
specific port where the destination
MAC address is located. | | 1 |
| What are two services that the OSPF Hello protocol provides?
A. It discovers neighbor routers
B. It gets routes from neighbors during startup
C. It helps elect a designated router
D. It allows administrator to test for connectivity between
two devices | | 1 |
| A device has 2 synchronous ports, 16 asynchronous ports, and
one ethernet port. What is this device most likely to be?
A. CSU/DSU
B. Access Server
C. Multiplexer
D. ISDN Terminal Adapter | | 1 |
| What are the five areas of the ISO Network Management Model?
A. Performance management
B. Accounting management
C. Flow management
D. Configuration management
E. Operating management
F. Fault management
G. Routing management
H. Security management | | 1 |
| What is the second step when creating a prototype?
A. Develop a test plan
B. Review the customer requirements
C. Investigate what the competition will be proposing
D. Define how big the prototype will be | | 1 |
| What is the first step in diagramming packet flow for the
terminals within a network?
A. Identify the end user nodes of all the terminals
B. Figure out the speed of all the servers
C. Find out where all the routers are located
D. Find out where all the switched are located | | 2 |
| When should you apply SAP filters to Netware service
advertisement messages?
A. When services are not required for a particular area or
network
B. Only after service advertisement messages have flooded
the network
C. Before any type of router convergence takes place
D. When no change in network services has taken place for 40
minutes | | 1 |
| 5. Which Two Settings must be configured in order to use the
GUI to configure Call Admission Control with voice Applications
| Pari-Networks | 1 |
| What are metrics used with IGRP?
A. Ticks
B. Load
C. Hops
D. Delay | | 1 |
| Which two of the following describe ASN.1 (Abstract Syntax
Notation One)?
A. It is an abstract routing protocol that is not used very
often.
B. It is an OSI language for describing data types
independent of particular computer structures and
representation techniques.
C. Consists of only one basic routing algorithm.
D. Uses BER (Basic Encoding Rules). | | 1 |
| The following are the four steps in establishing an X.25
virtual circuit. Place them in the correct order.
A. The PSE (Packet Switch Exchange) passes the packet to the
next remote DCE
B. The local DCE packet binder sends packet to the closest
PSE (Packet Switch Exchange)
C. The source DTE sends packet to the local DCE
D. The remote DCE examines the packet header of destination DTE | | 1 |
| SNMP agents are:
A. Management devices
B. NMS (Network Management Stations)
C. network devices such as routers, switches, or hubs
D. PDUs | | 1 |
| When would you suggest static routes to your customers?
A. When scalability is important
B. When bandwidth is limited
C. When the network will be changing frequently
D. Always suggest static routes | | 1 |
| What set of Frame Relay enhancements offer extensions for
managing complex internetworks?
A. CMT
B. SNMP
C. LMI
D. RMON | | 1 |
| EIGRP was developed to improve what two protocols?
A. OSPF
B. RIP
C. BGP
D. IGRP | | 1 |
| What task do you complete to identify organizational
objectives that will reflect your design?
A. Business Objectives
B. Scheduling requirements
C. Vacation time
D. Meetings | | 2 |
| A remote user needs a static IP address to support a
specific application.Which remote access VPN addressing
technique supports this ?
| Pari-Networks | 2 |
| What are two ways to connect a PC to a LAN when using ATM
(Asynchronous Transfer Mode)?
A. ATM endpoint
B. ATM LAPB
C. ATM router
D. ATM switch | | 1 |
| What is an advantage of CHAP over PAP?
A. Passwords are stored on separate servers in encrypted form
B. CHAP sends passwords unencrypted to save connection time
C. CHAP does not attempt to verify whether the user is
authorized to access the requested resource
D. ID?s and passwords are automatically stored in cache | | 1 |
| |
| For more CCDA Interview Questions Click Here |
To Refer this Site to Your Friends 
Site Map