ALLInterview.com :: Home Page KalAajKal.com
 Advertise your Business Here     
Browse  |   Placement Papers  |   Company  |   Code Snippets  |   Certifications  |   Visa Questions
Post Question  |   Post Answer  |   My Panel  |   Search  |   Articles  |   Topics  |   ERRORS new
   Refer this Site  Refer This Site to Your Friends  Site Map  Bookmark this Site  Set it as your HomePage  Contact Us     Login  |  Sign Up                      
info       Did you received any Funny E-Mails from your Friends and like to share with rest of our friends? Yeah!! you can post that stuff   HERE
Google
 
Categories  >>  Certifications  >>  Cisco Certifications  >>  CCNA
 
 


 

 
 CCNA interview questions  CCNA Interview Questions
 CCDA interview questions  CCDA Interview Questions
Question
What are the two components of an IPX address?

A. network number IP address

B. MAC address node number

C. network number MAC address

D. network number arched number
 Question Submitted By :: Guest
I also faced this Question!!     Rank Answer Posted By  
 
  Re: What are the two components of an IPX address? A. network number IP address B. MAC address node number C. network number MAC address D. network number arched number
Answer
# 1
Answer: C
 
Is This Answer Correct ?    2 Yes 0 No
Guest
 

 
 
 
Other CCNA Interview Questions
 
  Question Asked @ Answers
 
Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version  1
If you are running Token Ring with Novell IPX routing, which encapsulation should you use? A.) SAP B.) SNAP C.) 802.5 D.) 802.2  1
Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)  1
What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router  1
WHAT IS SERIAL TRANSMISSIONS,PARALLELL TRANSMISSION ASD-Lab2
Identify the order of the 5 step encapsulation? 1) Create the segment 2) Convert the frame to bits 3) Create the packet 4) Create the frame 5) User creates the data A.) 1,2,4,2,5 B.) 2,1,3,4,5 C.) 5,1,3,4,2 D.) 5,3,4,1,2  1
Which configuration mode and command combination sets the bandwidth metric of a Frame Relay connection? A. router(config)# clock rate 56 B. router(config)# bandwidth 56 C. router(config)# bandwidth 56000 D. router(config)# clock rate 56000  2
Identify 3 characteristics of an IP address? A.) Contains a network portion and a host portion B.) 32 bits long C.) Unique to each network D.) Part of the default Cisco configuration E.) Referred to as the hardware address  1
What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place  1
Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured  1
Identify 3 IP applications? A.) AURP B.) ARP C.) Telnet D.) SMTP E.) DNS F.) RARP  2
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup  2
What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase  2
IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port  1
Which of the following are examples of the Transport Layer? A.) Token Ring B.) UDP C.) TCP D.) IP E.) SQL F.) LLC  2
Which of these is the Private key? A. Bear B. Cave C. Indian D. Cowboy  1
What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network  1
what is the diffrence betwwen telnet and ssh.this question is asked by nikhil and i am plasing the answer here insteed of his personal mail.  4
What command can be used to test IPX connectivity? A.) Ping 2e.000.0045.8923 B.) Ping 192.168.100.1 C.) Ping ipx 2e.0000.0045.8923 D.) Ipx ping 2e.0000.0045.8923  3
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services  2
 
For more CCNA Interview Questions Click Here 
 
 
 
 
 
   
Copyright Policy  |  Terms of Service  |  Help  |  Site Map 1  |  Articles  |  Site Map  |   Site Map  |  Contact Us interview questions urls   External Links 
   
Copyright © 2007  ALLInterview.com.  All Rights Reserved.

ALLInterview.com   ::  Forum9.com   ::  KalAajKal.com