| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What is the bandwidth capacity of one ISDN B channel
A. 64 kbps
B. 128 kbps
C. 512 kbps
D. 1.54 mkbps | | 3 |
| Name a major component of the Point-to-Point Protocol (PPP) to
negotiate and set up control options on the WAN data link.
A.) RFC 1661
B.) High Level Datalink Protocol (HDLC)
C.) Challenge Handshake Authentication Protocol (CHAP)
D.) SS7
E.) Link Control Protocol (LCP) | | 2 |
| Hi Jitendera, I need ur suggestion. I completed my CCNA
certification & also hving some sort of real time
experience. Now i m planning to do CCNP. Little bit
confusion is that whether it wud be better for me to go for
CCNP ya CCNA (Security). As off my goal is to reach CCIE
(Security & Switching/Routing). So tell me some solution of
my confusion yaar..!!!
Thanx & Regards
Shahin.. | | 1 |
| Which of the following are ways to provide login access to a
router?
A.) HTTP
B.) Console
C.) Telnet
D.) Aux Port
E.) SNMP
F.) LLC | | 1 |
| Which commands would assign and enable IPX on an interface ?
A.) enable netware
B.) enable novell-ether
C.) router#(config)ipx routing
D.) You must first enable IPX globally and then
assign the network number to the interface .
E.) enable ipx
F.) router#(config-if)ipx network 4a | | 1 |
| Which IP packet field will prevent endless loops?
type-of-service
identificationf
lags
time-to-live
header checksum
| | 1 |
| What are hold-downs used for?
A.) To prevent regular update messages from reinstating a
route that has
come back up
B.) Information received on an interface cannot be sent back
out the
same interface
C.) To prevent regular update messages from reinstating a
route that has
gone down
D.) To hold the routing table from being sent to another router | | 1 |
| Identify the 2 types of access-list filters that control SAP
traffic?
A.) Novell-ether
B.) Arpa
C.) Input-sap-filter
D.) Round-robin
E.) Output-sap-filter | | 1 |
| The PDU at the network layer is a ________
Packet
Frame
Segment
Bit
| | 3 |
| Identify the 2 commands that will display the status and
information about interface E0 only?
A.) show interface ethernet E0
B.) show interface E0
C.) show E0
D.) show int E0
E.) show interface | | 1 |
| What does the term Base refer to in 100BaseT
A. cabling type
B. singnal type
C. 100 mode type
D. spectrum used
E. speed category | | 2 |
| Identify the command to display the Frame Relay map table?
A.) Router# display frame-relay map
B.) Router# show frame-relay map
C.) Router(setup)# show frame-relay map
D.) Router# show map frame-relay | | 1 |
| What layer can optionally support reliability?
A.) Transport
B.) IP
C.) Physical
D.) Network
E.) Sub-physical layer | | 1 |
| What are three benefits of Integrated Services Digital
Network (ISDN) (Choose three)
A. PVCs are faster and more reliable
B. No specialized equipment is required
C. Data transfer is faster than typical modems
D. Call setup is faster than with standard telephone service
E. It carries many types of data tramp such as voice video
and data | | 1 |
| IPX traffic using different encapsulation types can go over
the same data link
A. True
B. False | | 1 |
| hi friend i hav difficulty n need to solve it...v need to
implement a new raw switch in company as to increase the no
of staff...snc raw switch by default is in server mode,i
wanna know 1.how to make a switch in client mode...2.how to
configure switch i mean to sy how to connect all switches to
network. | | 1 |
| Where shall i do CCNA cour??. can i do CCNA at home if yes
then where shall i get CCNA book or simmulator.or if not
then plz reff. me any good center in delhi | | 1 |
| Ping uses which Internet layer protocol?
A.) RARP
B.) ICMP
C.) ARP
D.) FTP | | 2 |
| Identify the 2 characteristics that TCP and UDP share in common?
A.) Both use port numbers to identify upper level applications
B.) Operate at the Network layer
C.) Both are Transport protocols
D.) Both are reliable communications | | 3 |
| Which layer is responsible for providing mechanisms for
multiplexing upper-layer application, session establishment,
and tear
down of virtual circuits?
A.) Session
B.) Network
C.) Physical
D.) Transport
E.) Application
F.) Presentation | | 2 |
| |
| For more CCNA Interview Questions Click Here |
Did you received any Funny E-Mails from your Friends and like to share with rest of our friends? Yeah!! you can post that stuff 
Site Map
