| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Why would you use static routing instead of dynamic routing?
A.) When you want automatic updates of the routing tables
B.) All the time
C.) When you have very few routes and want to conserve bandwidth
D.) When you have a gateway of last resort | | 1 |
| Identify the command to disable CDP on an interface?
A.) Router(config-if)# no cdp enable
B.) Router(config-if)# no cdp run
C.) Router# no cdp enable
D.) Router(config-if)# no cdp | | 1 |
| What type of switching creates variable latency through the
switch?
A.) Cut-Through
B.) Inverted
C.) Layer 4
D.) Multiplexed
E.) Store and Forward | | 1 |
| Identify 3 characteristics of IP RIP?
A.) Distance vector
B.) Administrative distance is 120
C.) Periodic updates every 60 seconds
D.) Uses a composite metric
E.) Can load balance | | 1 |
| Identify 2 features of PPP CHAP authentication?
A.) Username and password is sent in clear text
B.) Authentication messages are sent periodically during the
connection
C.) Less secure then PAP
D.) Local router 'challenges' the remote router | | 1 |
| You are a system administrator and you want to deny access to a
group of computers with addresses 172.30.16.0 to
172.30.31.0. Which
wildcard mask would you use?
A. 0.0.15.255
B. 0.0.255.255
C. 0.0.31.255
D. 0.0.127.255
E. 0.0.255.255 | | 1 |
| As a system administrator, you need to set up one Ethernet
interface on the Cisco router to allow for both sap and
Novell-ether encapsulations. Which set of commands will
accomplish this?
A. interface ethernet 0.1
ipx encapsulation Novell-ether
ipx network 9e
interface ethernet 0.2
ipx network 6c
B. interface ethernet 0
ipx encapsulation Novell-ether
ipx network 9e
interface ethernet 0
ipx encapsulation sap
ipx network 6c
C. interface ethernet 0.1
ipx encapsulation Novell-ether
interface ethernet 0.2
ipx encapsulation sap
D. interface ethernet 0.1
ipx encapsulation Novell-ether
ipx network 9e
interface ethernet 0.2
ipx encapsulation sap
ipx network 6c | | 1 |
| Hello Every one. Can anyone please explain me the 7 OSI
Layers with some general example? I am trying to learn it
from last few months but i cant i realy need it. Thanks | | 1 |
| Which OSI Reference Layer controls end-to-end (host to host)
communication?
A.) Transport
B.) Physical
C.) Datalink
D.) Network
E.) Session | | 1 |
| 1 what is the number of telnet session in the cisco router
a 1
b 2
c 3
d 4
e 5 | | 3 |
| IP extended access lists use which of the following as a
basis for
permitting or denying packets?
A.) destination address
B.) all of the above
C.) protocol
D.) source address
E.) port | | 1 |
| Identify the command to determine if CDP is enabled?
A.) show enable cdp
B.) show cdp enabled
C.) show cdp run
D.) show cdp | | 2 |
| A big part of the overhead on a network is broadcasts. You
divide a large number of hosts into smaller individual
networks and separate them with the proper device
According to proper networking terminology you have created
separate _______________________,
User Domains
Broadcast Domains
Collision Areas
Broadcast Areas
| | 1 |
| What information can you get from CDP info: (choose all that
apply)
A.) Hardware platform
B.) One address per protocol
C.) Software platform
D.) Hostname
E.) The same info as show version
F.) Incoming/outgoing port | | 1 |
| Which of the following use PVCs at layer 2?
A.) X.25
B.) HDLC
C.) Frame relay
D.) ISDN | | 1 |
| How does inter- VLAN communication take place?
A. It takes place through any Cisco router
B. It takes place through a Cisco router that can run ISL
C. It takes place through a router but this disables all the
router a security and filtering functionality for the VLANS
D. For nonroutable protocals (e.g. NetBeui) the router
provides communications between VLAN domains
E. Inter-VLAN communication is not possible because each
VLAN is a separate broadcast domain | | 3 |
| Identify the hardware component used to store buffers, tables,
running-configuration etc?
A.) NVRAM
B.) ROM
C.) RAM
D.) Flash | | 1 |
| What is the standard ISDN term for a non-native analog
telephone?
A.) TE1
B.) TA
C.) LE
D.) TE2
E.) ET | | 1 |
| What utility can you use to see the path a packet takes
through an
internetwork?
A.) Route
B.) SNMP
C.) Trace
D.) Ping | | 2 |
| Which two statements accurately define IP addressing rules?
(Choose two)
A. IP multicast addresses start with 240
B. A host Carbon of all 1 a indicates a network broadcast
C. The value of zero (0) in the host Carbon means all hosts
on the network
D. IP addresses are four octets long and contain a network
Carbon and a host Carbon | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
