| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Your PC has been configured with IP Address 192.168.3.25
and a subnet mask of 255.255.255.0. Which of the following
IP Addresses is a valid default gateway address for your
PC?
192.168.3.0 255.255.255.0
192.168.3.2 255.255.255.0
192.168.3.25 255.255.255.0
192.168.4.1 255.255.255.255
| | 1 |
| hi friends i have some problem regarding technical round
ahr round plz tell me what should the right answer
technical questions
1 what is brouter
2 what is the menaing of 10 base2, 10 base 5 and 10baset
3 what is diffrence between bit rate and baud rate.
and this question was tooooooooooo much difficult to me
that
hr said to me that
rank me after the taking the all short of interview | | 5 |
| What command can you type to view the connections after
telneting
into multiple routers simultaneously?
A.) sh users
B.) sh ports
C.) sh host
D.) sh sessions | | 1 |
| Identify the prompt displayed if in privileged exec mode?
A.) Router(config)#
B.) Router#
C.) Router>
D.) Router(priv)# | | 1 |
| Identify the switching method that receives the entire frame
then
dispatches it?
A.) Cut-through
B.) Receive and forward
C.) Store and forward
D.) Fast forward | | 1 |
| There are two processes to pair MAC address with IP
addresses. Which process finds an IP address from a MAC
address?
A. RARP
B. ARP
C. RIP
D. IGRP | | 2 |
| Which ISDN protocol prefix specifies switching and signalling?
A.) I
B.) E
C.) Q
D.) S | | 1 |
| An ISDN BRI circuit can be described as which of the following?
A.) 3B channels
B.) 2-64Kbps B channels and 1-16Kbps D channel
C.) none of the above
D.) 2-64Kbps B channels and 1-16Kbps C channel | | 1 |
| What is the default LMI type for Cisco Routers that are using
Frame-Relay?
A.) Annex D
B.) Q933A
C.) Cisco
D.) IETF
E.) ARPA
F.) Anex A | | 2 |
| Which type of LAN segmentation device enables high speed
data exchange?
A. hub
B. bridge
C. switch
D. repeater | TCS | 2 |
| Identify the command to configure the router to boot from an IOS
located on a TFTP server?
A.) boot system tftp IOS.exe 172.16.5.1
B.) boot system tftp 172.16.5.1 IOS.exe
C.) boot system flash tftp 172.16.5.1
D.) boot system IOS.exe 172.16.5.1 | | 1 |
| Where is the backup configuration file stored?
A.) RAM
B.) ROM
C.) Console
D.) NVRAM | | 1 |
| When you mistakenly type the wrong command
at the Router# prompt the router does a
DNS lookup which takes about 20 seconds.
Which command can you enter to prevent the
router doing this in future? | | 3 |
| What is the standard ISDN term for a native ISDN modem?
A.) ET
B.) LE
C.) TE2
D.) TE3
E.) TA | | 1 |
| Why Clock rate command is not configured on ethernet
interface of a router? | | 4 |
| How can you add the 192.168.100.0/30 network to EIGRP without
involving the
192.168.100.4/30 network as well? | | 3 |
| What is difference between standard and extended access-list | HCL | 8 |
| Identify the command to determine if CDP is enabled?
A.) show enable cdp
B.) show cdp enabled
C.) show cdp run
D.) show cdp | | 1 |
| Which layer is responsible for synchronizing sending and
receiving
applications?
A.) Presentation
B.) Session
C.) Transport
D.) Application
E.) Network | | 1 |
| hi friends i am jitendera kumar sinha.i have a question in
mind that what is the diffrence between router and l3 switch
i serched on google and found that switch L3 is best in lan
and router are best in wan and switch are more faster then
router.beside that any short of technical diffrence if you
body know then plz plz and plz reply.
my 2nd question is that why we canot replace router with L3
switches (donot tell that it is costly then router).i want
any technical cause.
this is 1 am hope in noon when ever i logg again i will find
the answer posted by you.
thanks onse again
plz pzl make reply
thanks
jitendera kumar sinha
jitenerasinha.it@gmail.com
| | 5 |
| |
| For more CCNA Interview Questions Click Here |
To Refer this Site to Your Friends 
Site Map
