| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What is the Network Layer of the OSI responsible for?
A.) Bridging
B.) Routing packets through an internetwork
C.) Regenerating the digital signal
D.) Gateway services | | 2 |
| Which three devices can be used to convert the user data
from the
DTE into a form acceptable to the WAN service's facility?
A. Modem
B. CSU/DSU
C. TA/NT1
D. CO
E. SS7 | | 1 |
| What do the following statements in an extended access list
accomplish?
access-list 101 deny TCP 172.16.4.0 0.0.0.255 172.16.3.0
0.0.0.255 eq 21
access-list 101 deny TCP 172.16.4.0 0.0.0.255 172.16.3.0
0.0.0.255 eq 20
access-list 101 permit TCP 172.16.4.0 0.0.0.255 0.0.0.0
255.255.255.255
A. This will block ftp traffic.
B. This will block http traffic.
C. This will permit ftp traffic.
D. This will permit tftp traffic. | | 1 |
| How many collisions are caused by transmitting and receiving
frames simultaneously in a full-duplex Ethernet technology?
A. one
B. two
C. none
D. several | | 1 |
| Identify the command that specifies Serial 0 in slot 1?
A.) Router(config)# interface serial1/1
B.) Router(config)# interface serial1/0
C.) Router(config)# interface serial0.1
D.) Router(config)# interface serial0/1 | | 1 |
| A big part of the overhead on a network is broadcasts. You
divide a large number of hosts into smaller individual
networks and separate them with the proper device
According to proper networking terminology you have created
separate _______________________,
User Domains
Broadcast Domains
Collision Areas
Broadcast Areas
| | 1 |
| Which two statements accurately define IP addressing rules?
(Choose two)
A. IP multicast addresses start with 240
B. A host Carbon of all 1 a indicates a network broadcast
C. The value of zero (0) in the host Carbon means all hosts
on the network
D. IP addresses are four octets long and contain a network
Carbon and a host Carbon | | 1 |
| Which layer allows multiple Ethernet devices to uniquely
identify
one another on the Datalink layer?
A.) Transport
B.) Session
C.) Network
D.) Datalink - MAC Sublayer
E.) Datalink - LLC Sublayer | | 3 |
| Which command, that is used to test address configuration,
uses Time-To-Live (TTL) values to generate messages from
each router.
A. trace
B. ping
C. telnet
D. bootp | | 1 |
| Bridges work at what layer of the OSI model?
A.) Data Link
B.) Network
C.) Physical
D.) Application | | 2 |
| can we configure multiple as on single router using eigrp | IBM | 1 |
| When configuring the subnet mask for an IP address, which
formats can be used?A. dotted-decimal.
B. Hexadecimal
C. Bit-count
D. Octal
E. Binary | | 1 |
| What does a Standard IP Access-list use as test criteria?
A.) IP source address
B.) IP source and destination address, protocol numbers and
port numbers
C.) IPX source and destination address
D.) Source MAC address | | 1 |
| What is BGP attribute & How many types of attributes are
used by BGP??? | Hathway | 3 |
| What is LSA? How many types of LSA used by OSPF version 2?? | Hathway | 2 |
| What is a key use of a device hardware address?
A. to obtain a vendor code / serial number from the user
B. to transmit a frame from one Interface to another Interface
C. to transmit a packet from one local device to another
local device
D. to transmit data from one local device to a remote device
across the internet
E. to contain logical information about the device to use
for end-to-end transmission | | 1 |
| Identify the command that displays ethernet0/1 interface status?
A.) show interface ethernet0/1
B.) show interface ethernet e0/1
C.) show interface ethernet0.1
D.) show ethernet0/1 | | 3 |
| Which IP packet field will prevent endless loops?
type-of-service
identificationf
lags
time-to-live
header checksum
| | 1 |
| friends i have 3ree prob which is asked in ibm india in
technical round
1 what is ftp(this was easy i had answered)
2 why we use ftp(i think it is a tough one)
3 how can we enable ftp in the widows xp.
friend i need these question answer as soon as possible
if it is possible to reply within the eveing then i always
obeyliged to you
i am espacily looking towards the jitendera sinha who make
most of the valuable answer
loking toward you
nidhi mall | IBM | 3 |
| Which statement is true regarding full duplex?
A.) Allows for transmission and receiving of data simultaneously
B.) Only works in a multipoint configuration
C.) Does not affect the bandwidth
D.) Allows for transmission and receiving of data but not a
the same time | | 2 |
| |
| For more CCNA Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
