Repeaters work at which layer of the OSI model? A.) Network B.) Sessi

Advertise your Business Here

Refer this Site

Login | Sign Up


	Do you have a collection of Interview Questions and interested to share with us!! Please send that collection to along with your userid / name. ThanQ

Categories >> Certifications >> Cisco Certifications >> CCNA

CCNA Interview Questions

CCDA Interview Questions

Question

Repeaters work at which layer of the OSI model?

A.) Network

B.) Session

C.) Transport

D.) Physical

Question Submitted By :: Guest

I also faced this Question!!

Rank

Answer Posted By

Re: Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical

Answer
# 1

Answer: D

Is This Answer Correct ?

9 Yes

0 No

Guest

Re: Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical

Answer
# 2

D. Physical layer.

It amplify the signal.It doesn't know about the data.

Is This Answer Correct ?

4 Yes

2 No

Bala

Re: Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical

Answer
# 3

Ans : D

Physical layer devices


Hubs, repeaters, network adapters, Host Bus Adapters

Is This Answer Correct ?

3 Yes

1 No

M Haja Bahurudeen

Question	Asked @	Answers
Other CCNA Interview Questions


Which protocol works at the Internet layer and is responsible for making routing decisions? A.) UDP B.) IP C.) TCP D.) ARP		2
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction		2
Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory		2
7. What is an advantage to using switches in your network? A. Addressing of hosts by DHCP B. Ease of administration C. Stops broadcast storms D. Works like a repeater	iGate	2
Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?		2
What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II		1
Which command will copy the routers configuration from NVRAM to a Network file server? A.) copy start tftp B.) copy start tftp server C.) copy tftp startup-config D.) copy running-config tftp E.) copy startup-config tftp		1
What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.		1
Identify the switching method that receives the entire frame then dispatches it? A.) Cut-through B.) Receive and forward C.) Store and forward D.) Fast forward		2
Identify 3 UDP characteristics? A.) Reliable communication protocol B.) Applications that use UDP must incorporate reliability C.) Connection-less oriented D.) Incorporates no handshaking		2
Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.		1
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc		1
Which of the following can reply to a Novell Get Nearest Server (GNS) request? A.) Local Novell server B.) Remote Novell Printer C.) Cisco router D.) Novell client		1
what is the subnet for the host ip address 172.16.210.0/22	IBM	4
Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector		1
What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface		1
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services		2
Two of the protocols that can be carried in the Protocol field of an IP packet are? A. TCP B. UDP C. FTP D. TFTP		2
Which IP Address Class can have 64,000 subnets with 64,000 hosts per subnet? A. Class B B. Class A C. Class C D. Class D		2
Which OSI Reference Layer is concerned with path determination? A.) Datalink B.) Physical C.) Network D.) Transport E.) Session		2

For more CCNA Interview Questions Click Here


Copyright Policy \| Terms of Service \| Help \| Site Map 1 \| Articles \| Site Map \| Site Map \| Contact Us \|

Copyright © 2007 ALLInterview.com. All Rights Reserved.

ALLInterview.com :: Forum9.com :: KalAajKal.com