Which of the following is a characteristic of a switch, but not of a ro

Advertise your Business Here

Refer this Site

Login | Sign Up


	Ask Questions on ANYTHING, that arise in your Daily Life at FORUM9.COM

Categories >> Certifications >> Cisco Certifications >> CCNA

CCNA Interview Questions

CCDA Interview Questions

Question

Which of the following is a characteristic of a switch, but
not of a

router?

A.) Switches forward packets based on the IPX or IP address
in the frame

B.) Switches forward packets based on the IP address in the
frame

C.) Switches forward packets based on the MAC address in the
frame

D.) Switches forward packets based only on the IP address in
the packet

Question Submitted By :: Guest

I also faced this Question!!

Rank

Answer Posted By

Re: Which of the following is a characteristic of a switch, but not of a router? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

Answer
# 1

Answer: C

Is This Answer Correct ?

1 Yes

0 No

Guest

Question	Asked @	Answers
Other CCNA Interview Questions


What does the User Datagram Protocol (UDP) provide? A.) Connectionless datagram service. B.) FECN & BECN C.) Flow control and error checking. D.) Name resolution. E.) Path discovery.		1
Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) Ping D.) Console E.) Trace		1
Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list		2
You have an IP host address of 201.222.5.121 and a subnet mask of 255.255.255.248. What is the broadcast address? A. 201.222.5.127 B. 201.222.5.120 C. 201.222.5.121 D. 201.222.5.122		1
Which OSI Reference Layer controls application to application communication? A.) Datalink B.) Network C.) Transport D.) Session E.) Physical		1
Of the following characteristics, which apply to UDP? Connection-oriented Connectionless Error checking Low overhead Best-effort delivery		3
What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category		2
Given the IPX address 4a.0002.1111.a999, what is the network ID and what is the node ID? A.) net 4a host 0002.1111.a999 B.) net a999 node 0002.1111 C.) net 0002.1111.a999 node 4a D.) net 0002.1111 node a999		1
What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface		1
Dear Mr. JITENDERA KUAMR SINHA how are and how is your family? Anyway can u send me your personal email address?		4
You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.		1
Which of the following are valid WAN terms? A.) DTE B.) DCE C.) Demarc D.) CPE		2
If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through		1
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services		2
what is the default ad value of the interface directly coneted to router. as for exmaple ad value of ospf is 90 then from ehternet the network is conected whta is difault value of that directly conected interface. what is the defalt ad value of bgp whta is access llist and how many type of access list what is vlan what is vpn how e congigure the router what is mpls these are the question skrd to me at tcs i have replyed all ecxept the first one	TCS	1
what is the difference b/w pap and chap,and give comand to configure pap cahp on two router r1 and r2,		1
The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC		2
Which protocol works at the Internet layer and is responsible for making routing decisions? A.) UDP B.) IP C.) TCP D.) ARP		2
A ISDN PRI circuit can be described as which of the following? A.) 24 B channels and 1-64Kbps D channel B.) 23 B channels and 1-64Kbps D channel C.) 2-D channels and 1-C channel D.) 2-64Kbps B channels and 1-16Kbps D channel		1
Which two protocol tools use ICMP? (Choose two) A. ping B. telnet C. configure D. traceroute E. show commands F. standard access lists		3

For more CCNA Interview Questions Click Here


Copyright Policy \| Terms of Service \| Help \| Site Map 1 \| Articles \| Site Map \| Site Map \| Contact Us \|

Copyright © 2007 ALLInterview.com. All Rights Reserved.

ALLInterview.com :: Forum9.com :: KalAajKal.com