| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which protocol will let neighbor routers know if your
internetwork
experienced congestion on a serial port?
A.) BootP
B.) IP
C.) ICMP
D.) ARP
E.) FTP
F.) RARP | | 1 |
| what is the high order bit in class a
1
11
110
10
mine answer 1 | | 2 |
| Why Authentication Header (AH) is not compatible with the
network that using NAT??????
Jitu, looking for u specially...!!!! U knw why i m looking
for u..!!! | | 1 |
| Identify the 3 key features of the Cisco Discovery Protocol?
A.) Off by default
B.) Will allow for the discovery of layer 3 addresses on
neighbor routers
C.) Verifies connectivity
D.) Open standard
E.) Does not require any layer 3 protocols to be configured | | 1 |
| What command can be used to test IPX connectivity?
A.) Ping 2e.000.0045.8923
B.) Ping 192.168.100.1
C.) Ping ipx 2e.0000.0045.8923
D.) Ipx ping 2e.0000.0045.8923 | | 1 |
| Which technology is used by Catalyst switches to resolve
topology loops and ensure data flows properly through a
single network path?
A. virtual LANS (VLANS)
B. frame filtering
C. cut-through switching
D. spanning-tree protocol | | 1 |
| Identify the access-list range for an extended IP access-list?
A.) 800 - 899
B.) 1 - 99
C.) 1000 - 1099
D.) 100 - 199 | | 4 |
| Select the physical interfaces that PPP can be configured on
a Cisco
router:
A. Asynchronous serial
B. HSSI
C. ISDN
D. Synchronous serial | | 1 |
| What are hold-downs used for?
A.) To prevent regular update messages from reinstating a
route that has
come back up
B.) Information received on an interface cannot be sent back
out the
same interface
C.) To prevent regular update messages from reinstating a
route that has
gone down
D.) To hold the routing table from being sent to another router | | 1 |
| A network is vow congested currently all the devices are
connected through a hub. Which would best decrease
congestion on this network?
A. add a second hub
B. replace the hub with a router
C. replace the hub with a switch
D. replace the hub with a repeater | | 1 |
| Switching methods include cut-through, store and forward,
and a modified version of the first two methods. Which
statement about switching methods is true?
A. The store and forward method has low latency
B. The cut through method of switching has high latency
C. The modified version holds the packet in memory until 50
percent of the packet reaches the switch
D. The modified version holds the packet in memory until the
data spoon of the packet reaches the switch | | 3 |
| 2. What are the valid ways to segment a LAN? (Choose all
that apply)
A. Repeater
B. Bridge
C. Switch
D. Router
| | 2 |
| What was the key reason the International Organization for
Standardization released the OSI model?
A. users could access network servers faster
B. different vendor networks could work with each other
C. the industry could create a standard for how computers work
D. network administrators could increase the overall speed
of their network | | 1 |
| Identify the command to view the configuration-register value?
A.) show register
B.) display config-register
C.) show config
D.) show version | | 1 |
| Identify 3 characteristics of the Network layer (OSI layer 3)?
A.) Connnection oriented
B.) Path determination
C.) Supports multiplexing
D.) Manages sessions
E.) Packet forwarding | | 1 |
| What's the default CDP holdtime in seconds for Cisco routers?
A.) 30 seconds
B.) 180 seconds
C.) 90 seconds
D.) 60 seconds | | 3 |
| Using the TCP/IP protocol suite, a message is sent from host
A to a destination IP address on the same LAN. How does
host A determine the destination of a MAC address?
A. It uses a proxy APP
B. It uses APP requests
C. It uses PARP requests
D. It uses a router lookup table | | 1 |
| Which statement is true regarding full duplex?
A.) Allows for transmission and receiving of data simultaneously
B.) Only works in a multipoint configuration
C.) Does not affect the bandwidth
D.) Allows for transmission and receiving of data but not at
the same time | | 1 |
| Which symbol in the router prompt indicates you are in the
privelaged mode?
A. >
B. !
C. #
D. : | | 3 |
| Which 3 statements describe default encapsulation and LMI type
configuration?
A.) There are only four encapsulations and 3 LMI type options
B.) The LMI type config term options
C.) In release 11.3 the LMI type is autosensed
D.) The default LMI is Cisco
E.) IETF encap must be configured unless the connecting
routers are both
cisco | | 1 |
| |
| For more CCNA Interview Questions Click Here |
To Refer this Site to Your Friends 
Site Map
