Identify the purpose of ARP?
A.) Avoiding routing loops
B.) Determining a workstation's IP address
C.) Sending a directed broadcast
D.) Determining a workstation's MAC address
Answers were Sorted based on User's Feedback
Answer / kapilasdhir
D.) Determining a workstation's MAC address
·ARP was invented for this reason . It relates IP’s to MAC
addresses only on media that supports broadcasts .
·Each node maintains a cache called the ARP cache , which
holds a table of IP’s against MAC addresses .
Is This Answer Correct ? | 6 Yes | 0 No |
As a system administrator, you need to provide your routers with a Domain Name System (DNS) server. How many DNS servers can you specify with one command? A. 6 B. 1 C. 2 D. 4
The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
how many vlan can be configured on a single switch
Mention the ranges for the private IP?
Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame
What is CIDR?
What are the conversion steps of data encapsulation?
What is the maximum number of subnets that can be assigned to networks when using the address 172.16.0.0 with a subnet mask of 255.255.240.0? (Assume older version UNIX workstations are in use.) A. 16 B. 32 C. 30 D. 14 E. It is an invalid subnet mask for the Network.
Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102
What command displays the OSPF section of the running-configuration?