| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| On an ISDN BRI interface, the control channel is the 'D'
channel.
What is
the rate of this channel?
A.) 64 Kbps
B.) 1.544 Mbps
C.) 128 Kbps
D.) 2.048 Mbps
E.) 16 Kbps | | 2 |
| Which network mask should you place on a Class C address to
accommodate a user requirement for five networks with a
maximum of 17 hosts on each networks
A. 255.255.255.192
B. 255.255.255.224
C. 255.255.255.240
D. 255.255.255.248 | | 7 |
| Identify 3 Fast Ethernet technologies?
A.) 100 Base FastEther
B.) 100 Base FX
C.) 100 Base T4
D.) 100 Base TX | | 1 |
| What would be the proper wildcard mask to permit all odd
numbered hosts on the 10.48.0.0/12 network?
access-list 1 permit 10.48.0.0 0.15.255.255
access-list 1 permit 10.48.0.1 0.15.255.254
access-list 1 permit 10.48.0.0 0.15.255.1
access-list 1 permit 10.48.0.0 0.0.0.254
access-list 1 permit 10.48.0.0 0.0.0.255
| | 5 |
| What is Cisco's default encapsulation method on serial
interfaces?
A.) ANSI
B.) Cisco
C.) Q933a
D.) HDLC | | 1 |
| Sequence and acknowledgement numbers are used for?
A.) Layer transitioning
B.) Flow control
C.) Port number addressing
D.) Reliability | | 1 |
| what is route aggregation | | 2 |
| A user device that connects to a DCE must be which of the
following?
A.) DTE
B.) CPE
C.) Demarc
D.) DCE
E.) CO | | 1 |
| Which protocol works at the Internet layer and is
responsible for
making
routing decisions?
A.) UDP
B.) IP
C.) TCP
D.) ARP | | 3 |
| Which of the following is an example of a Transport Layer
protocol?
Ethernet
IP
TCP
RS-232
| | 1 |
| What is the purpose and default value of the CDP timer command?
A.) 90 seconds; interval before an entry expires
B.) 60 seconds; interval between updates
C.) 60 seconds; interval before an entry expires
D.) 90 seconds; interval between updates | | 1 |
| What is the diiffernce between windows xp & windows 2000?
| VigaTech | 5 |
| What is the routing algorithm used by RIP and IGRP?
A.) OSPF
B.) Link-state
C.) Dynamic
D.) Distance Vector | | 2 |
| What key do you use to view the last command?
A.) Left Arrow
B.) Ctrl-P
C.) Up Arrow
D.) Right Arrow | | 2 |
| In distance-vector routing, there is a problem known as the
'count
to infinity' problem. What is the most direct solution to this?
A.) Defining a Maximum.
B.) You can not solve the 'count to infinity' problem with a
distance
vector protocol.
C.) Poison Reverse.
D.) Triggered Updates.
E.) Split Horizon. | | 1 |
| Identify the following components of the IPX address
2e.0000.0065.ed43
A.) Not a valid IPX address
B.) Network = 2e, Subnet = 0000, Node = 0065.ed43
C.) Network = 2e.0000, Node = 0065.ed43
D.) Network = 2e, Node = 0000.0065.ed43 | | 1 |
| Identify the command to copy a configuration file from a TFTP
server to a routers active configuration?
A.) Router# copy running-config tftp
B.) Router# copy tftp running-config
C.) Router# copy tftp 172.16.0.1 running-config
D.) Router(config)# copy tftp running-config | | 1 |
| Identify the command to configure the router to boot from an
alternate IOS located in flash?
A.) boot system flash IOS.exe
B.) boot system tftp IOS.exe 172.16.5.1
C.) boot system alternate IOS.exe
D.) boot system rom IOS.exe | | 1 |
| bWhich form of PPP error detection on Cisco routers monitors
data
dropped on a link?
A. Quality
B. Magic Number
C. Error Monitor
D. Droplink | | 1 |
| Identify the purpose of the wildcard mask?
A.) Match a certain portion of the IP address while ignoring
the rest of
the address
B.) Determine the class of the IP address
C.) Determine the network portion of an IP address
D.) Hide the host portion of an IP address | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
