| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What is the command to manually enter a static route?
A.) IP route network
B.) IP route
C.) IP route < destination network>
D.) IP route | | 1 |
| thnx Jitender singh...as u told to install a stp in switches
and problem vil b get solved...i wanna kno how to install
stp in switches??
plz tel me detailled steps...
thanx for ur answer. | | 1 |
| Which three types of connectors are commonly associated
with Cisco's V.35 serial cables? (Choose three.)
0 RJ 11
1 DB 60
2 Winchester 15 pin
3 DB 9
4 smart serial
5 RJ 45
| | 3 |
| What is the syntax to use to configure the port on a
Catalyst 5000
switch?
A.) slot port/type
B.) type slot/port
C.) port slot/type
D.) port type/slot | | 2 |
| how to troubleshoot when protocols is down and link is not
getting up | HCL | 5 |
| Which three are typical operational phases in a basic
connection oriented neloyord service? (Choose three)
A. call setup
B. data transfer
C. load balancing
D. call termination
E. call priortization
F. data segmentation
G. data link identification | | 1 |
| Which OSI layer establishes, maintains and terminates sessions
between
applications?
A.) Application
B.) Physical
C.) Data-Link
D.) Presentation
E.) Network
F.) Session | | 1 |
| A router on one side of a PPP link uses the resonance RTR1
and the password COPP1-PWD. Which configuration line on
RTR1 enables a connection between RTR1 and another router
named RTR2?
A. username, RTR2 password COPR1-PWD,
B. username, RTR1 password COPR1-PWD,
C. username, RTR2 password COPR2-PWD,
D. username, RTR1 password COPR2-PWD, | | 1 |
| which of the following address represent unicast address
A 224.1.5.2
B ffff.ffff.ffff.ffff
C 192.168.24.59/30
D 255.255.255.255
E 172.138.128.255
plz tell what should be answer plz tell with explanation
| IPsoft | 3 |
| Identify the command that will display the RIP routes
entering and
leaving the router?
A.) Router(config)# debug ip rip
B.) Router# debug ip rip
C.) Router>debug ip rip
D.) Router# debug rip routes | | 1 |
| What does the command show access-lists 101 list?
A. all defended access lists
B. all access lists within the router
C. the contents of standard access list 101
D. the contents of defended access list 101 | | 1 |
| Hi Gyes, here is new question. can you provide answer of
following question
Like linux, can we windows as router?
If yes how can we able to do this, | | 2 |
| Which statement about Ethernet networks is true?
A. The advantage of a full duplex is the ability to transmit
data over 111 cable
B. Full duplex Ethernet requires a point-to-point connection
when only two nodes are present
C. Ethernet switches can use full duplex mode to connect
multiple nodes to a single pod of a switch
D. Half duplex is a cut through packet processing method
that is vow fast little error correction Full duplex is a
store and forward method that is slower but has better error
correction | | 1 |
| What is the maximum hop count for Link-State protocols?
A.) 15
B.) there is no hop count limit
C.) 256
D.) 16 | | 1 |
| Identify the 3 kinds of routes IGRP advertises?
A.) Interior
B.) Dynamic
C.) System
D.) Exterior | | 1 |
| Based upon the 1st octet rule identify the range for a Class A
address?
A.) 1 - 126
B.) 192 - 223
C.) 128 - 191
D.) 1 - 191 | | 1 |
| Routers that have Flash memory typically have a ore loaded
copy of place IOS software. Which command should you use to
make a backup copy of the software image onto a given
network server?
A. copy flash tftp
B. save copy to tftp
C. write backup tftp
D. write, backup -server-name-
E. copy backup to -server-name- | | 1 |
| Identify 1 characteristic of RARP?
A.) IP to MAC address translation
B.) Connectionless delivery of packets
C.) Can be used to initiate remote O/S load sequence
D.) Generates error and control messages | | 1 |
| What is a back off on an 802.3 networks?
A. It is latency in store and forward switching
B. It is the time used for token passing from machine to machine
C. It is the retransmission delay that is enforced when a
collision occurs
D. It is the result of two nodes transmitting at the same
time. The frames from each transmitting device collide and
are damaged | | 1 |
| Which of the following will apply IPX sap access list 1010 for
incoming traffic, assume you are at the interface configuration?
A.) ipx input-sap-filter 1010 in
B.) ipx input-sap-filter 1010
C.) ipx access-group 1010 in
D.) ipx access-list 1010 in | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Did you received any Funny E-Mails from your Friends and like to share with rest of our friends? Yeah!! you can post that stuff 
Site Map
