| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Repeaters work at which layer of the OSI model?
A.) Network
B.) Session
C.) Transport
D.) Physical | Wipro | 3 |
| Which network mask should you place on a Class C address to
accommodate a user requirement for five networks with a
maximum of 17 hosts on each networks
A. 255.255.255.192
B. 255.255.255.224
C. 255.255.255.240
D. 255.255.255.248 | | 7 |
| there is three mode of vtp let there are three switch s1 in
server mode s2 in transparent mede and s3 in clint mode
then will that tranparnt mode going to effect the network if
yes then how and if no then what it will do | IBM | 1 |
| Which fields of an IP packet provide for fragmentation of
datagrams to allow differing MTUs in the internet?
A. Identification
B. Flags
C. Frag Offset
D. Type of Service
E. Total Length | | 1 |
| Which command will show you if you have a DTE or DCE
cable connected to an interface? | | 3 |
| What is the protocol number for UDP?
A.) 6
B.) 17
C.) 25
D.) 21 | | 2 |
| The CSMA/CD Ethernet IEEE committee is defines as which of the
following?
A.) 802.2
B.) 802.3
C.) 802.4
D.) 802.5 | | 1 |
| Hello Every one. Actually its my first time to using this
site and first time to posting a question. Actually i need
to know about CCNA Exam. Please can any one tell me about
the Exam style and any recommendation for study? Best
Regards to all the Friends | | 1 |
| Hi,can anyone explain me in brief about ccna security.
waiting for your answer | | 2 |
| what are the 3ree way for implementing vlan on cisco switches
what is the layer hierarchy of the cisco
what is the best place of implementing standard access list
what is q stand for isdn
these are the challanging question for me
i am waiting for jitendera sinha answer(it is challenge for
u i have seen lots of answer given by u )it is a challenge
in the frendshipmode plz donot take other wise
| | 2 |
| When the router runs out of buffer space, this is called
________.
A. Source Quench
B. Redirect
C. Information Request
D. Low Memory | | 1 |
| Which addresses are INCORRECTLY paired with their class?
A. 128 to 191, Class B
B. 192 to 223 Class B
C. 128 to 191, Class C
D. 192 to 223, Class C | | 2 |
| Which two commands allow you to verify address configuration
in your unternetword? (Choose two)
A. ping
B. trace
C. verify
D. test ip
E. Echo ip
F. config ip | | 2 |
| what is the difference between switch and router?? | Thomson | 7 |
| Identify the command to configure the router for IGRP autonomous
system 100?
A.) Router(config)# router igrp 100
B.) Router> router igrp 100
C.) Router# router igrp 100
D.) Router(config)# router igrp | CMS | 2 |
| Identify the hardware component that stores the bootstrap
program?
A.) ROM
B.) NVRAM
C.) Booter load
D.) RAM
E.) Flash | | 2 |
| To monitor IP igrp traffic, you can use "debug IP igrp
transaction" or "debug IP igrp events". How do you display
information about IPX routing update packets?
A. debug routing
B. debug ipx transaction
C. debug ipx routing activity
D. debug ipx events | | 1 |
| In which three situations is a hold down timer reset?
(Choose three)
A. when the hold down timer expires
B. when infinity is finally defined as some maximum number
C. when the router exchanges update summaries at area borders
D. when the router detects faulty LSPs propagating through
the internetwork
E. when another update is received indicating a new route
with a better metric
F. when another update is received indicaing the original
route to the network has been restored
G. when the router receives a processing task proportional
to the number of links in the internetwork | | 1 |
| Identify the protocol to test connectivity without
configuring any
layer 3
protocols?
A.) TCP
B.) Ping
C.) IP
D.) CDP
E.) Telnet | | 1 |
| When determining whether or not to route a LAN segment,
which rule
of thumb do you use?
A.) 60/40
B.) 50/50
C.) 80/20
D.) 90/10
E.) 70/30 | | 1 |
| |
| For more CCNA Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
