| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What is the command to allow you to type Tokyo instead of the IP
address 172.16.30.1 to access a router named Tokyo?
A.) config t, ip host Tokyo 172.16.30.1
B.) config t, ip hostname Tokyo 172.16.30.1
C.) config t, hostname Tokyo 172.16.30.1
D.) config t, ip hostname 172.16.30.1 Tokyo | | 1 |
| Which two encapsulation names are correctly paired with the
Cisco IOS encapsulation names? (Choose two)
A. Ethernet_II-ARPA
B. Ethernet_802.3-SAP
C. Ethernet_802.2-LLC
D. Ethernet_SNAP-SNAP | | 1 |
| What is the default CDP broadcast update rate for Cisco routers?
A.) 120 seconds
B.) 60 seconds
C.) 30 seconds
D.) 90 seconds | | 1 |
| Given the Novell IPX address 1aceb0b.0000.0c12.3456 which
part is
the network portion of the address?
A.) 0000
B.) 1
C.) 3456
D.) 1ace
E.) 0000.0c12.3456
F.) 1aceb0b | | 2 |
| what is the diffination of bandwidth. | | 1 |
| Which two does 100BaseT use?
A.) CSMA/CD
B.) IEEE 802.5
C.) 802.3u
D.) Switching with 53-byte cells | | 3 |
| Layer 1 and Layer 2 devices must forward a broadcast.
Which of the following devices fall into this category?
Gateway
Switch
Router
All of the above.
| | 1 |
| Hi Anyone can share the latest ICND1 (640-822)dumps updated
at 30 september 2009. specialy to Jatendra if you have any
updated about the ICND1 exam.will be remain thankful. | | 2 |
| With distance vector routing protocols, it is never useful
to send
the same routing update packet back out the same interface
that it was
learned. This concept is called what?
A.) Holddown timers
B.) Poison Reverse
C.) Count to infinity
D.) Split Horizon
E.) Link State | | 2 |
| R1#sh ip nat translations
Pro Inside global Inside local Outside local
Outside global
icmp 15.1.1.1:11 10.1.1.1:11 30.1.1.1:11
30.1.1.1:11
icmp 15.1.1.1:12 10.1.1.1:12 20.1.1.1:12
20.1.1.1:12
icmp 15.1.1.1:13 10.1.1.1:13 21.1.1.1:13
21.1.1.1:13
icmp 15.1.1.1:14 10.1.1.1:14 31.1.1.1:14
31.1.1.1:14
R1#
So my question is that after every ip address [:] is used &
some number. 15.1.1.1{:11}... what is this colon & number
indicate.
Can anyone tel me this..!!!
Thanking you advance.
Shahin | | 3 |
| What is true when creating static route?
A.) The mask parameter is optional
B.) The administrative distance is required
C.) The gateway parameter is required
D.) The administrative distance is optional | | 1 |
| what is meant by domain ?
what is mean by DNS? | | 14 |
| Identify the hardware component that stores the backup
configuration?
A.) RAM
B.) NVRAM
C.) Flash
D.) ROM | | 1 |
| Which IP Address Class can have 16 million subnets but
support 254 hosts?
A. Class C
B. Class A
C. Class B
D. Class D | | 3 |
| Identify the command that displays traffic statistics on
serial0/1?
A.) display interface serial0/1
B.) show interface serial0/1
C.) show seria0/1 stats
D.) show interface serial0/1 stats | | 1 |
| You have OSPF traffic flooding your network
via one of your router interfaces. Write the access
list line that will deny all ospf traffic. Don't
worry about the other lines of the access list. | | 1 |
| What does the acronym ARP stand for?
A.) Address Resolution Phase
B.) ARP Resolution Protocol
C.) Address Resolution Protocol
D.) Address Recall Protocol | | 2 |
| here is your question sahin
Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight
is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1,
K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP.
I knew about it from ICND 2 cisco press book.
Three more questions -
a) If we change the K value (I mean metric weight)on a
router what will happen???
b) When redistribution is necessary in EIGRP. Is there any
condition for that???
c) What is reference bandwidth for metric calculation in
EIGRP. As we know, in OSPF, on a CISCO router reference
bandwidth is 10Mbps. | | 3 |
| Which OSI layer performs code conversion, code formatting and
encryption?
A.) Physical
B.) Data-Link
C.) Application
D.) Transport
E.) Presentation
F.) Network | | 1 |
| PICT & JPEG are examples of what layer in the OSI seven
layer model?
A.) Transport
B.) Presentation
C.) Application
D.) Datalink
E.) Network
F.) Session | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
