| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| How can you add the 192.168.100.0/30 network to EIGRP without
involving the
192.168.100.4/30 network as well? | | 3 |
| What is a key use of a device hardware address?
A. to obtain a vendor code / serial number from the user
B. to transmit a frame from one Interface to another Interface
C. to transmit a packet from one local device to another
local device
D. to transmit data from one local device to a remote device
across the internet
E. to contain logical information about the device to use
for end-to-end transmission | | 1 |
| Which statement about the flow control function of TCP is true?
A. TCP makes no snarl to check for lost or duplicate data
packets
B. The application layer must sequence data packets when
using TCP
C. TCP controls the flow of UDP data through negative
acknowledgements (NAK)
D. TCP is a connection-oriented protocol that acknowledges
receipt of data packets and is considered reliable | | 1 |
| What is an advantage of local area network (LAN) segmentation?
A. smaller collision domains
B. elimination of broadcasts
C. decreased cost of implementation
D. larger number of users within the same domain | | 2 |
| What is proxy-ARP and how it is used and configured | | 1 |
| Identify the purpose of ICMP?
A.) Avoiding routing loops
B.) Send error and control messages
C.) Transporting routing updates
D.) Collision detection | Hughes | 2 |
| Which OSI layer supports the communication component of an
application?
A.) Data-Link
B.) Physical
C.) Session
D.) Presentation
E.) Application
F.) Transport | | 1 |
| What is the standard ISDN term for a native ISDN telephone?
A.) ET
B.) TE1
C.) TE2
D.) LE
E.) TA | | 1 |
| Dear Mr.Shahin thank you very much for your advise i realy
thanks full to you.
Best of luck | | 2 |
| what is the default ad value of the interface directly
coneted to router.
as for exmaple ad value of ospf is 90 then from ehternet
the network is conected whta is difault value of that
directly conected interface.
what is the defalt ad value of bgp
whta is access llist and how many type of access list
what is vlan
what is vpn
how e congigure the router
what is mpls
these are the question skrd to me at tcs i have replyed all
ecxept the first one
| TCS | 1 |
| Using the TCP/IP protocol suite, a message is sent from host
A to a destination IP address on the same LAN. How does
host A determine the destination of a MAC address?
A. It uses a proxy APP
B. It uses APP requests
C. It uses PARP requests
D. It uses a router lookup table | | 1 |
| Which three commands are used to configure information into
RAM on a router? (Choose three)
A. configure memory
B. configure terminal
C. configure overwrite
D. copy tftp startup-config
E. copy running-config startup-config
F. copy startup-config running-config | HCL | 5 |
| b Which protocol for PPP LCP (Link Control Protocol) performs a
challenge handshake?
A. CHAP
B. PAP
C. UDP
D. IPX | | 1 |
| What does -1 signify in an extended IPX access list?
A. permit this host
B. deny this host
C. permit only this subnet
D. any host or any network | | 2 |
| Identify the 3 key features of the Cisco Discovery Protocol?
A.) Off by default
B.) Will allow for the discovery of layer 3 addresses on
neighbor routers
C.) Verify connectivity
D.) Open standard
E.) Does not require any layer 3 protocols to be configured | | 1 |
| Of the following switching types, which one has the highest
latency?
A.) Cut-through
B.) None
C.) Store-and-forward
D.) Fragment Free | | 1 |
| Identify the effect of Ctrl-Z?
A.) Exits back to privileged exec mode
B.) Disconnect from the router
C.) Abort the ping operation
D.) Exits privileged exec mode | | 2 |
| Windowing is a type of :
A.) Negative acknowledgement
B.) Address resolution
C.) Layer transition mechanism
D.) Flow control | | 1 |
| what is the difference between hdlc and ppp protocol | ASD-Lab | 4 |
| In regards to the ISDN BRI standard, which channel is used for
control?
A.) B
B.) D
C.) E
D.) I
E.) Q | | 2 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
