| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| There is an emergency fall-back 'skeleton' IOS stored in
read only
memory on all Cisco routers. What command would make the
router load the
IOS from
Read Only Memory?
A.) reload rom
B.) boot system rom
C.) load ios bootflash
D.) load ios rom
E.) bootsystem skeleton | | 2 |
| what is LAPB | ASD-Lab | 1 |
| 1 what is the number of telnet session in the cisco router
a 1
b 2
c 3
d 4
e 5 | | 3 |
| Why Authentication Header (AH) is not compatible with the
network that using NAT??????
Jitu, looking for u specially...!!!! U knw why i m looking
for u..!!! | | 1 |
| Which command switches from User mode to Privileged mode?
A.) login
B.) privilege
C.) admin
D.) enable
E.) enter
F.) root | | 2 |
| please name some routed protocol.
| | 1 |
| Which of the following are Session Layer standards?
A.) ASCII and EBCDIC
B.) MPEG and MIDI
C.) NFS and SQL
D.) JPEG and PICT | | 2 |
| Identify the 2 rules used when configuring a Distance Vector
routing
protocol?
A.) Physically connected network(s)
B.) Configure the classfull address, no subnets
C.) Enable CDP so neighbors can be detected
D.) Same autonomous network | | 1 |
| In regards to the ISDN BRI standard, which channel is used for
control?
A.) B
B.) D
C.) E
D.) I
E.) Q | | 1 |
| Which three protocols are corerectly matched to their
transport layer functions? (Choose three)
A. route selection IP
B. sliding window UDP
C. well known pods IP
D. route validation ICMP
E. connection oriented TCP
F. three way handshake TCP
G. no sequence and acknowledgement UDP | | 1 |
| Which frame has a Type field to identify the upper-layer
protocol?
A.) 802.3
B.) 802.2
C.) 802.5
D.) Ethernet_II | | 1 |
| Which is not a common problem with Distance-Vector routing?
A.) Slow convergence.
B.) Complex configuration.
C.) Routing loops.
D.) Periodic updates can slow convergence.
E.) Counting to infinity. | | 1 |
| Identify the command to configure the router for IGRP autonomous
system 100?
A.) Router(config)# router igrp 100
B.) Router> router igrp 100
C.) Router# router igrp 100
D.) Router(config)# router igrp | CMS | 2 |
| Which of the following are valid Cisco encapsulation type names?
A.) arpa = IPX Ethernet
B.) novell-ether = IPX Ethernet_802.3
C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring
D.) novell-fddi = IPX Fddi_Raw
E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring
F.) hdlc = HDLC on serial interfaces | | 1 |
| There is a process in Frame-Relay where LMI resolves an IP
address
from a DLCI number. What is this called?
A.) arp
B.) inverse arp
C.) rarp
D.) automap
E.) reverse arp
F.) arp | | 1 |
| Which of the following is an example of the Physical Layer?
A.) TCP
B.) ARP
C.) IP
D.) FDDI
E.) LLC
F.) Fast Ethernet | | 2 |
| Identify the statement which connects access-list 101 inbound to
interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in | | 1 |
| Cisco routers can secure the enable password with a one-way hash
algorithm. What command would encrypt the enable password
with the
strong encryption method?
A.) enable encrypt john
B.) password john
C.) enable secret john
D.) enable password john
E.) secret john
F.) enable password 5 john | | 1 |
| What do the following commands accomplish?
access-list 1 permit 172.16.0.0 0.0.255.255
interface ethernet 0
IP access-group 1 out
interface ethernet 1
IP access-group 1 out
A. Only traffic from the source network 172.16.0.0 will be
blocked.
B. Only traffic from the source network 172.16.0.0 will be
forwarded.
Non-172.16.0.0 network traffic is blocked.
C. Non-172.16.0.0 traffic will be forwarded.
D. All traffic will be forwarded. | | 1 |
| Identify 3 characteristics of ISDN?
A.) Transports voice and data
B.) Transports voice only
C.) Support both BRI and PRI
D.) Runs over existing phone lines
E.) Same as X.25 | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
