| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| In version 11.2 of the IOS, a Cisco router configured for
frame-relay can automatically detect the LMI type. What is
this known as?
A.) Psychic
B.) ESP
C.) Inverse ARP
D.) Hello
E.) Reverse ARP
F.) Autosense | | 1 |
| What is the default bandwidth of a serial connection?
A.) 1200 baud
B.) 1.544 Mbps (T1)
C.) 10 Mbps
D.) 96Kpbs | | 3 |
| Which of the following are solutions to the problems encountered
with Distance-Vector routing?
A.) Defining a Maximum
B.) Poison Reverse
C.) Triggered Updates
D.) Shortest path first algorithm.
E.) Split Horizon | | 1 |
| The Network layer works with which of the following:
A.) Globules
B.) Bits
C.) Packets
D.) Segments
E.) Frames | | 2 |
| What is the default interval for SAP updates?
A.) 60 seconds
B.) 15 seconds
C.) 30 seconds
D.) 120 seconds | ACS | 1 |
| Identify the command to configure the router to boot from an
alternate IOS located in flash?
A.) boot system flash IOS.exe
B.) boot system tftp IOS.exe 172.16.5.1
C.) boot system alternate IOS.exe
D.) boot system rom IOS.exe | | 1 |
| What should be the first command to create an access-list that
prevents all users on subnetwork 10.10.128.0, using subnet mask
255.255.192.0, from being
able to telnet anywhere?
A.) access-list 101 deny tcp 10.10.128.0 0.0.63.255 any eq
telnet
B.) access-list 101 deny tcp 10.10.128.0 255.255.0.0 any eq
telnet
C.) access-list 101 deny tcp 10.10.128.0 255.255.192.0 any
eq telnet
D.) access-list 101 deny tcp 10.10.128.0 0.0.192.255 any eq
telnet
E.) access-list 101 deny tcp 10.10.128.0 0.0.128.255 any eq
telnet
F.) access-list 101 deny tcp 10.10.128.0 0.0.127.255 any eq
telnet | | 3 |
| In Cisco IOS software which command displays the backup
configuration?
A. show flahh
B. show version
C. show tftp-config
D. show backup-config
E. show startup-config | | 1 |
| What does the following line for an access list do? 'access-list
101 deny tcp 3.4.5.0 0.0.0.255 any eq 23'
A.) deny all ftp traffic
B.) deny all ftp traffic from subnet 3.4.5.0
C.) deny all telnet traffic from subnet 3.4.5.0
D.) deny all ftp traffic to subnet 3.4.5.0
E.) deny all telnet traffic | | 1 |
| Identify 2 features of PPP PAP authentication?
A.) Username and password is sent in clear text
B.) Authentication messages are sent periodically during the
connection
C.) More secure than CHAP
D.) Remote node is control of authentication process | | 1 |
| What is the distance limitation for 100BaseT?
A. 305.955 ft
B. 7283.46 inches
C. 184 Meters
D. 185 Kilometers | | 3 |
| Which fields of an IP packet provide for fragmentation of
datagrams to allow differing MTUs in the internet?
A. Identification
B. Flags
C. Frag Offset
D. Type of Service
E. Total Length | | 1 |
| What is the default LMI type for Cisco Routers that are using
Frame-Relay?
A.) Gandalf5
B.) Q933A
C.) Cisco
D.) IETF
E.) ARPA
F.) SAP | | 2 |
| Identify the keystroke used to terminate the setup mode?
A.) Ctrl-K
B.) Crtl-C
C.) Ctrl-Z
D.) Crtl-End | | 1 |
| How often does IP RIP send out routing table updates by default?
A.) They send complete updates every 30 seconds
B.) They send partial updates every 30 seconds
C.) They send complete updates every 60 seconds
D.) They send partial updates every 60 seconds | | 2 |
| Which statement is true regarding Administrative distance?
A.) It is a metric
B.) Number of hops between two routers
C.) Trustworthiness of the routing information
D.) RIP Administrative distance is 100 | TCS | 1 |
| What is a characteristic of Store and Forward switches?
A.) They forward the frame before it is completely read.
B.) They work at wire speed.
C.) They are the same a Cut-Through switching.
D.) They read the entire frame and check CRC before forwarding.
E.) They decrease latency. | | 1 |
| What is the difference between OSPF Exteral Type 1 (O E1) &
External Type 2 (O E2) routes???? | | 3 |
| the situation iz like ths -at a specific time in our company
the internet connectivity goes off...v hav two networks in
our company...but out of it only one link goes down for 5-10
sec...a fastethernet port becomes down for few sec and
automatically becomes Up...
Is this occures becoz of Power??
If yes thn y the 2nd network is not affected?? | SoftTech | 1 |
| Explain usage of ICMP in IP routing | | 2 |
| |
| For more CCNA Interview Questions Click Here |
To Refer this Site to Your Friends 
Site Map
