Extended IP access-lists (100-199) can be used to control traffic. Whic

Advertise your Business Here

Refer this Site

Login | Sign Up


	Ask Questions on ANYTHING, that arise in your Daily Life at FORUM9.COM

Categories >> Certifications >> Cisco Certifications >> CCNA

CCNA Interview Questions

CCDA Interview Questions

Question

Extended IP access-lists (100-199) can be used to control
traffic.

Which command listed below will permit smtp mail to only
host 3.4.5.6 ?

A.) It is not possible for SMTP traffic

B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp

C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23

D.) access-list 102 permit tcp any any eq smtp

E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25

Question Submitted By :: Guest

I also faced this Question!!

Rank

Answer Posted By

Re: Extended IP access-lists (100-199) can be used to control traffic. Which command listed below will permit smtp mail to only host 3.4.5.6 ? A.) It is not possible for SMTP traffic B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23 D.) access-list 102 permit tcp any any eq smtp E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25

Answer
# 1

Answer: B E

Is This Answer Correct ?

1 Yes

0 No

Guest

Question	Asked @	Answers
Other CCNA Interview Questions


What is the function of the Transport layer and which protocols reside there? A.) MAC addressing - IP B.) Interhost communication - SQL, NFS C.) Best effort Packet delivery - TCP, UDP D.) End-to-end connections - TCP, UDP		1
Which service takes information from multiple sources and allocates bandwidth on a single media? A. Time-division Multiplexing (TDM) B. Signaling System 7 (SS7) C. X.25 D. Frame relay		1
Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces		1
Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells		1
Which technologies listed below help prevent network loops in a switched (bridged) environment? A.) Store-and-Forward B.) IEEE 802.1d C.) Diikjstra Algorithm D.) Cut-Through E.) Spanning Tree Protocol F.) Routing		1
Identify 1 characteristic of RARP? A.) MAC to IP address translation B.) Connectionless delivery of packets C.) Can be used to initiate remote O/S load sequence D.) Generates error and control messages		2
Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1		1
Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport		1
Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classful address, no subnets C.) Enable CDP so neighbors can be detected D.) Configure all networks in Area0		1
Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free		1
There are 2 types of PPP authentication supported by the Cisco IOS. What are they? A.) PAP B.) PREDICTOR C.) MD5 D.) CHAP E.) STACKER F.) MSCHAP		1
Identify the switching method that examines the destination MAC address as the frame is being received then begins forwarding the frame prior to receiving the entire frame? A.) Fragment-free B.) Store and Forward C.) Cut-through D.) Fast forward		1
How many valid host IP addresses are available on the following network/subnetwork? 176.12.44.161/30 A. 2 B. 30 C. 254 D. 16,382 E. 65,534		1
IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port		1
The benefits to segmenting with Bridges are which of the following? A.) Scalability B.) Datagram filtering C.) Manageability D.) Reliability		1
You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router		1
What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Novell-ether		1
Which command line statement determines the number of seconds a dialup connection can wait without any traffic before the router hangs up? A.) dialler max-time B.) dialler timeout C.) dialer idle-timeout D.) dialer hang-up E.) disconnect-timer		2
As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.		1
Which command switches from User mode to Privileged mode? A.) login B.) privilege C.) admin D.) enable E.) enter F.) root		2

For more CCNA Interview Questions Click Here


Copyright Policy \| Terms of Service \| Help \| Site Map 1 \| Articles \| Site Map \| Site Map \| Contact Us \|

Copyright © 2007 ALLInterview.com. All Rights Reserved.

ALLInterview.com :: Forum9.com :: KalAajKal.com