What is the command to allow you to type Tokyo instead of the IP
address
172.16.30.1 to access a router named Tokyo?
A.) config t, ip host Tokyo 172.16.30.1
B.) config t, ip hostname Tokyo 172.16.30.1
C.) config t, hostname Tokyo 172.16.30.1
D.) config t, ip hostname 172.16.30.1 Tokyo
You want to segment a network. The network is running SNA and Netbios. Which device should NOT be used to segment the network? A.) A store and forward switch. B.) A router. C.) A Catalyst 5000. D.) A cut-through switch. E.) A bridge.
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
Why do you use ‘service password encryption’?
Can you explain IKE phases? Can you explain IKE modes?
What is difference between baseband and broadband transmission in ccna?
what are layer hierarchy of cisco
What is the name of distance vector algorithm?
Identify the switching method that examines the destination MAC address as the frame is being received then begins forwarding the frame prior to receiving the entire frame? A.) Fragment-free B.) Store and Forward C.) Cut-through D.) Fast forward
whats the routing protocol supporting in both juniper , cisco routers.
Although Cisco IOS 11.2 and later can auto-detect the LMI type in Frame Relay, which command will force the LMI type to q933a? A.) frame-relay lmi-type q933a B.) encapsulation frame-relay q933a C.) don't need to, it is the default D.) encapsulation q933a E.) encapsulation frame-relay type=q933a
How many total hosts are possible with a Class C address and a subnet mask of 255.255.255.252? A. 4 B. 30 C. 60 D. 62 E. 112 F. 124
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full