| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which of these is the Private key?
A. Bear
B. Cave
C. Indian
D. Cowboy | | 1 |
| What is the IP extended access list range?
A.) 1000-1099
B.) 100-199
C.) 1-99
D.) 101-200 | | 2 |
| Which two statements about a bridge are true? (Choose two)
A. A bridge floods multicasts
B. A bridge floods broadcasts
C. A bridge does not flood multicasts
D. A bridge does not flood broadcasts | | 1 |
| Port selection is done at which layer of OSI reference
model????? | | 3 |
| Where is the backup configuration file stored?
A.) RAM
B.) ROM
C.) Console
D.) NVRAM | | 1 |
| Identify 2 features of PPP CHAP authentication?
A.) Username and password is sent in clear text
B.) Authentication messages are sent periodically during the
connection
C.) Less secure then PAP
D.) Local router 'challenges' the remote router | | 1 |
| Identify the command to display the status of the Frame Relay
virtual circuit?
A.) Router# show frame-relay virtual-circuit
B.) Router(config)# show frame-relay pvc
C.) Router# show frame-relay pvc
D.) Router# show virtual | | 1 |
| The two sublayers of the IEEE Data Link Layer are which of the
following?
A.) Link and Logical Control
B.) Data Link and LLC
C.) Logical Link Control and Media Access Control
D.) Data Link and MAC | | 2 |
| Which technologies listed below help prevent network loops in a
switched (bridged) environment?
A.) Store-and-Forward
B.) IEEE 802.1d
C.) Diikjstra Algorithm
D.) Cut-Through
E.) Spanning Tree Protocol
F.) Routing | | 1 |
| What are the OSPF router rules???? | NIIT | 6 |
| hi... i am a beginner to CCNA... i find it hard understandin
collision domain n broadcast domain.. please don tell me the
definition.. i read the definitions many times... i need a
more detailed explanation... like whn i read the definition
it sounds simple... but i don understand whn they say it
like a hub has one collision domain and one broadcast
domain... and if collisions happen inside collision
domain... i am confused... please help me... :( | | 4 |
| In distance-vector routing, there is a problem known as the
'count
to infinity' problem. What is the most direct solution to this?
A.) Defining a Maximum.
B.) You can not solve the 'count to infinity' problem with a
distance
vector protocol.
C.) Poison Reverse.
D.) Triggered Updates.
E.) Split Horizon. | | 1 |
| What is the result of using a hierarchical addressing framework?
A. increased availability of addresses
B. decreased distance between routers
C. increased router memory requirements
D. no need to maintain routing information | | 2 |
| When a router knows the IP address, but does not know the MAC
address of
the device it wishes to contact, it uses the ARP (Address
resolution
protocol) to determine the MAC address. After it learns the
MAC address,
it stores this information in the ARP cache. What is the
command to view
the ARP cache?
A.) sh mac
B.) show cache
C.) show arp
D.) sh arp interfaces
E.) show ip cache | | 2 |
| in the ospf area network dr and bdr selection procedure occur
let there are 4 router in that n/w r1 have the higher priority
then r2 and r2 have higher priority then r3 and so on
like that
r1>r2>r3>r4
now as we know that selection of dr and bdr based upon the
router priority so in this case r1 will be dr and r2 will be
bdr
now my question is that if i am going to implement 5th
router which have greater priority then r1 then will it become dr atomically
remember that i am not going change my 5 or 1st router property
answer that one please | | 2 |
| Which addresses are INCORRECTLY paired with their class?
A. 240 - 255, Class D
B. 240 - 255, Class E
C. 224 - 239, Class D
D. 224 - 239, Class E | | 2 |
| Identify the hardware component that stores the bootstrap
program?
A.) ROM
B.) NVRAM
C.) Booter load
D.) RAM
E.) Flash | | 2 |
| Identify the command to configure the router to boot from an
alternate IOS located in flash?
A.) boot system flash IOS.exe
B.) boot system tftp IOS.exe 172.16.5.1
C.) boot system alternate IOS.exe
D.) boot system rom IOS.exe | | 1 |
| If a router uses dynamic routing, how does it learn the
route to remote networks?
The router uses a DHCP request to obtain remote network
numbers.
The router uses a routing protocol to exchange routing
info. with other routers.
The router uses DNS request packets to obtain remote
network numbers.
The Network Administrator manually configures the remote
networks.
| | 1 |
| Identify the default IPX serial encapsulation?
A.) Novell-Ether
B.) SDLC
C.) SNAP
D.) HDLC | | 1 |
| |
| For more CCNA Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
