| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| How many access lists are allowed per interface?
A. One per port, per protocol
B. Two per port, per protocol
C. Unlimited
D. Router interface +1 per port. | | 2 |
| Which of the following is an example of the Physical Layer?
A.) SQL
B.) IP
C.) LLC
D.) DDP
E.) Ethernet | | 1 |
| Identify 3 LAN technologies?
A.) FDDI
B.) HDLC
C.) HSSI
D.) X.25
E.) 802.3
F.) 802.5 | | 1 |
| Which global configuration command will tell the router to load
the IOS file 'IOS_filename' from FLASH memory at the next boot?
A.) boot system flash
B.) boot system flash IOS_filename
C.) boot system IOS_filename flash
D.) boot system tftp IOS_filename tftp_address
E.) config-register 0x0102 IOS_ filename | HSBC | 1 |
| Which statement should you use to deny FTP access (only)
from network 210 93 105 0 to network 223 8 151 0?
A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access
list 1 permit any
B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151
0 0 0 0 255 eq ftp
C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp
access list 100 permit hp any any
D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151
0 0 0 0 255 eq ftp access list 100 permit ip any any | | 1 |
| Identify 3 characteristics of switches?
A.) Increase available bandwidth
B.) Decrease broadcast traffic
C.) Support full duplex in a multipoint topology
D.) Make fowarding decision using MAC address
E.) Create collision domains | | 1 |
| let threr are three router 1 is cionected to two and two is
conected to three
that is
1----2----3
now we can ping 2 from 3 and 1 to two but we are not able
to ping 1 to 3 let router 1 is local and rest of two are
remote what should be urs troubleshoot steps
| Volvo | 2 |
| How would you set the clock rate to 64K, on interface serial 0,
from the interface configuration mode?
A.) clock rate 64000
B.) bandwidth 64
C.) clock 64
D.) rate 64
E.) clock rate 64k
F.) clock rate 64 | | 1 |
| Which of the following are Presentation Layer standards?
A.) JPEG and PICT
B.) MPEG and MIDI
C.) ASCII and EBCDIC
D.) NFS and SQL | | 2 |
| What is a function of a reliable transport layer connection?
A. route selection
B. acknowledgements
C. session checkpoints
D. system authentication | | 2 |
| Layer 1 and Layer 2 devices must forward a broadcast.
Which of the following devices fall into this category?
Gateway
Switch
Router
All of the above.
| | 1 |
| Novell NetWare has an Ethernet frame type called Ethernet_SNAP.
What is the matching Cisco command line keyword for this
encapsulation
method?
A.) arpa
B.) sap
C.) snap
D.) gns
E.) dix
F.) novell-ether | | 1 |
| You want to enable both arpa and snap encapsulation on one
router interface. How do you do this?
A. The interface can handle multiple encapsulation types
with no extra configuration.
B. Assign two network numbers, one for each encapsulation
type.
C. Enable Novell-ether to run multiple encapsulation types.
D. Both arpa and snap are enabled by default so you don't
have to configure anything. | | 1 |
| MIDI and MPEG are examples of what layer of the OSI seven layer
model?
A.) Session
B.) Network
C.) Datalink
D.) Transport
E.) Application
F.) Presentation | | 1 |
| What is the standard ISDN term for a non-native analog
telephone?
A.) TE1
B.) TA
C.) LE
D.) TE2
E.) ET | | 1 |
| Which three functions are supported by connection oriented
servkps? (Choose three)
A. connection parameters are synchronized
B. any loss or duplication of packets can be corrected
C. the data packet is independently routed and the service
does not guarantee the packet will be processed in order
D. a data communication path is established between a
requesting entity and the peer device on the remote end system | | 1 |
| what is secure hand shake protocol | | 2 |
| A ISDN PRI circuit can be described as which of the following?
A.) 24 B channels and 1-64Kbps D channel
B.) 23 B channels and 1-64Kbps D channel
C.) 2-D channels and 1-C channel
D.) 2-64Kbps B channels and 1-16Kbps D channel | | 1 |
| What does the term Base refer to in 100BaseT
A. cabling type
B. singnal type
C. 100 mode type
D. spectrum used
E. speed category | | 2 |
| X.25 is characterized by layer 2 identifiers, and what else?
A.) Virtual Lan's
B.) Session Layer
C.) Transport Layer
D.) Routing Updates
E.) PVC's | | 1 |
| |
| For more CCNA Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
