| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which layer defines bit synchronization?
A.) Application
B.) Network
C.) Transport
D.) Physical
E.) Session
F.) Session | | 1 |
| Identify the 3 Internet layer IP protocols?
A.) NetBios
B.) IPX
C.) ARP
D.) IP
E.) RARP | | 1 |
| In regards to the OSI seven-layer model, at which layer is
EBCDIC
and ASCII?
A.) Presentation
B.) Application
C.) Transport
D.) Session
E.) Datalink
F.) Network | | 1 |
| Switching methods include cut-through, store and forward,
and a modified version of the first two methods. Which
statement about switching methods is true?
A. The store and forward method has low latency
B. The cut through method of switching has high latency
C. The modified version holds the packet in memory until 50
percent of the packet reaches the switch
D. The modified version holds the packet in memory until the
data spoon of the packet reaches the switch | | 3 |
| Where is the point between the customers site and the phone
carrier that responsibility changes?
A.) CO
B.) Demarc
C.) DCE
D.) DTE
E.) CPE | | 1 |
| which term use to allow user to conect the remote n/w with
ppp dail up conection
ras
sap
sonet
mane answer rsa | | 1 |
| hi friends i have a problem.plz solve this.
i am working some where and i have the number of
swtitch.once my project manger says that we are going to
exapnd our number of employ so plz attech an another
switch.i asked to my jr network engineer that take a witch
and implemnt on that n/w,as he implement the switch on that
n/w.thats network get down,
plz tell me what is the reason of that.
| | 1 |
| intial information of packey occur on which layer
application
sessions
physical
mine answer physical | | 1 |
| What are two functions of the ICMP protocol? (Choose two)
A. to map IP addresses to Ethernet addresses
B. to map common names to network addresses
C. to forward SNMP alerts to management consoles
D. to generate an echo reply in response to a ping test
E. to send a host or pod unreachable message from a router
to the source of an undeliverable packet | | 1 |
| Which global configuration command will tell the router to load
the IOS file 'IOS_filename' from FLASH memory at the next boot?
A.) boot system flash
B.) boot system flash IOS_filename
C.) boot system IOS_filename flash
D.) boot system tftp IOS_filename tftp_address
E.) config-register 0x0102 IOS_ filename | HSBC | 1 |
| Identify the effect of Ctrl-Z?
A.) Exits back to privileged exec mode
B.) Disconnect from the router
C.) Abort the ping operation
D.) Exits privileged exec mode | | 2 |
| What is an administrative distance of 0 mean?
A.) 0 means unbelievable
B.) 0 is for EIGRP
C.) 0 is the default distance for directly connected networks
D.) 0 means unreachable | | 2 |
| When discussing static routes, what is the gateway parameter
used
for?
A.) Determining the dynamic route
B.) Defining the subnet
C.) Defining the Administrative Distance
D.) Determining the next hop | | 1 |
| what is used for passive intercae comand
mine answer-to prevent to take update from outside | | 1 |
| In Cisco IOS software which command displays the backup
configuration?
A. show flahh
B. show version
C. show tftp-config
D. show backup-config
E. show startup-config | | 1 |
| Identify 3 characteristics of a MAC address?
A.) Burned into the NIC
B.) 48 bits long
C.) Length is 32 bits
D.) Used to deliver the frame to the end device
E.) Contains a network portion and a host portion | | 1 |
| Which layer is responsible for routing through an internetwork?
A.) Physical
B.) Session
C.) Network
D.) Transport
E.) Application
F.) Data Link | | 3 |
| Which of the following will apply IPX sap access list 1010 for
incoming traffic, assume you are at the interface configuration?
A.) ipx input-sap-filter 1010 in
B.) ipx input-sap-filter 1010
C.) ipx access-group 1010 in
D.) ipx access-list 1010 in | | 1 |
| Identify the access-list range for an extended IP access-list?
A.) 800 - 899
B.) 1 - 99
C.) 1000 - 1099
D.) 100 - 199 | | 1 |
| Eight stations connected to separate 10 Mobs pods on a Layer
2 switch will give each station how many Mobs of bandwidth?
A. 1.25
B. 4
C. 16
D. 10
E. 80 | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
