| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| A network is vow congested currently all the devices are
connected through a hub. Which would best decrease
congestion on this network?
A. add a second hub
B. replace the hub with a router
C. replace the hub with a switch
D. replace the hub with a repeater | | 1 |
| What is the IP extended access list range?
A.) 1000-1099
B.) 100-199
C.) 1-99
D.) 101-200 | | 2 |
| Which encapsulation methods are most commonly used with
dialup Integrated Services Digital Network (ISDN)?
A. IP and IPX
B. IP and PPP
C. PPP and SDLC
D. PPP and HDLC | | 1 |
| What parameter is used with statically assigned routers to tell
packets which interface to use to reach a distant network?
A.) Mask
B.) Subnet
C.) Default gateway
D.) Interface | | 1 |
| Identify 3 IP applications?
A.) AURP
B.) ARP
C.) Telnet
D.) SMTP
E.) DNS
F.) RARP | | 1 |
| Identify the keystroke used to terminate the setup mode?
A.) Ctrl-K
B.) Crtl-C
C.) Ctrl-Z
D.) Crtl-End | | 1 |
| How do you disable CDP on the entire Router?
A.) Router#no cdp run
B.) Rotuer(config-if)# no cdp enable
C.) Router(config)# no cdp enable
D.) Router(config)# no cdp run | | 1 |
| Which three are typical operational phases in a basic
connection oriented network service?
A. call setup
B. data transfer
C. load balancing
D. call termination
E. caller ID
F. call prionflication
G. data segmentation
H. data and momma
I. data link identification
J. callering book | | 1 |
| Identify the 2 commands to copy a configuration from a TFTP
server
to RAM?
A.) configure network
B.) configure overwrite
C.) copy backup-config running-config
D.) copy tftp running-config | | 1 |
| bWhich form of PPP error detection on Cisco routers monitors
data
dropped on a link?
A. Quality
B. Magic Number
C. Error Monitor
D. Droplink | | 1 |
| Which service uses telephone control messages and signals
between
the transfer points along the way to the called destination?
A. Signaling System 7 (SS7)
B. Time-division Multiplexing (TDM)
C. X.25
D. Frame relay | | 1 |
| Identify the purpose of ARP?
A.) Avoiding routing loops
B.) Determining a workstation's IP address
C.) Sending a directed broadcast
D.) Determining a workstation's MAC address | | 2 |
| In version 11.2 of the IOS, a Cisco router configured for
frame-relay can automatically detect the LMI type. What is
this known as?
A.) Psychic
B.) ESP
C.) Inverse ARP
D.) Hello
E.) Reverse ARP
F.) Autosense | | 1 |
| Identify 2 HDLC characteristics?
A.) Default serial encapsulation
B.) Open standard
C.) Supports Stacker compression
D.) Supports point-to-point and multipoint | | 1 |
| What is an example of a valid MAC address?
A. 192.201.63.251
B. 19-22-01-63-25
C. 0000.1234.FEGA
D. 00.00.12.34.FE.AA | | 2 |
| Which type of switching is considered to be 'wire speed?'
A.) Cut-Through
B.) Multiplexed
C.) Inverted
D.) Layer 4
E.) Store and Forward
F.) Layer 3 | | 1 |
| Which command would you type to show SAP and RIP updates you are
receiving on an interface?
A.) sh ipx servers
B.) sh ipx traffic
C.) sh ipx interface
D.) sh ipx route | | 1 |
| You are a network administrator and have been assigned the
IP address of 201.222.5.0. You need to have 20 subnets with
5 hosts per subnet. What subnet mask will you use?
A. 255.255.255.248
B. 255.255.255.128
C. 255.255.255.192
D. 255.255.255.240 | | 1 |
| What is the link state routing protocol in the TCP/IP
protocol stack?
A. IP
B. IS-IS
C. NLSP
D. OSPF
E. RIP version 2 | | 1 |
| When determining whether or not to route a LAN segment,
which rule
of thumb do you use?
A.) 60/40
B.) 50/50
C.) 80/20
D.) 90/10
E.) 70/30 | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
