| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which command will start the process for a Cisco IOS file image
upgrade?
A.) download
B.) copy tftp flash
C.) copy flash tftp
D.) download flash
E.) network | | 2 |
| What are characteristics of UDP
A. It is reliable and acknowledged
B. It is unreliable and acknowledged
C. It is reliable and unacknowledged
D. It is unreliable and unacknowledged | | 2 |
| The following selections show the command prompt and the
configuration of the IP network mask. Which two are
correct?
A. Router#term IP netmask-format { bitcount | decimal |
hexadecimal }
B. Router(config-if)#IP netmask-format { bitcount | decimal
| hexadecimal }
C. Router(config-if)#netmask-format { bitcount | decimal |
hexadecimal }
D. Router#ip netmask-format { bitcount | decimal | hexadecimal } | | 1 |
| what is the boot seqance of cisco router | | 5 |
| IPX routing updates occur how often?
A.) Every 30 seconds
B.) Every 60 seconds
C.) Only as needed
D.) When the remote router asks for an update | | 1 |
| Identify the statement which connects access-list 101 inbound to
interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in | | 1 |
| Identify the correct pair of Novell Ethernet encapsulation and
Cisco terminology?
A.) Ethernet II, Snap
B.) Ethernet 802.3, Novell-Ether
C.) Ethernet SNAP, Arpa
D.) Ethernet 802.2, Snap | | 1 |
| In Cisco IOS software which command displays the backup
configuration?
A. show flahh
B. show version
C. show tftp-config
D. show backup-config
E. show startup-config | | 1 |
| Which switching technology can reduce the size of a
broadcast domain?
A.) Cut-Through
B.) Store-and-Forward
C.) Spanning Tree Protocol
D.) RARP
E.) ARP
F.) VLAN | | 1 |
| what is ip address and what is the difference between the ip
address and mac address why we are not using mac address instead of ip address | IBM | 3 |
| What is the default LMI type for Cisco Routers that are using
Frame-Relay?
A.) Gandalf5
B.) Q933A
C.) Cisco
D.) IETF
E.) ARPA
F.) SAP | | 2 |
| Identify the purpose of ARP?
A.) Avoiding routing loops
B.) Determining a workstation's IP address
C.) Sending a directed broadcast
D.) Determining a workstation's MAC address | | 3 |
| NetWare IPX addressing uses a network number and a node
number. Which statements are true?
A. The network address is administratively assigned and can
be up to 16 hexadecimal digits long.
B. The node address is always administratively assigned.
C. The node address is usually the MAC address.
D. If the MAC address is used as the node address, then IPX
eliminates the use of ARP. | | 1 |
| Define Poison Reverse?
A.) To prevent regular update messages from reinstating a
route that has
gone down
B.) Packets sent out that are not destined for a network go
to the default
network
C.) Information received on an interface cannot be sent back
out the same
interface
D.) When a network goes down, that network is advertised with an
infinite metric | | 1 |
| Identify 3 characteristics regarding CDP?
A.) On by default
B.) Shows only directly connected neighbors
C.) Requires IP or IPX
D.) 60 second update interval by default
E.) 30 second updates interval by default | | 1 |
| Which statement about Ethernet switches is true?
A. Symmetric switching allows connection between pods of
unlike bandwidth and does not require memory buffering
B. Memory Buffering is used to prevent a bottleneck when
pods of different bandwidth are connected on a symmetric switch
C. The latency can be reduced if the switch utilizes the
store and forward method of switching store and forward is
better for error detection
D. The cut through method of switching is faster because the
switch forwards the packet to the destination as soon as it
reads the destination address | | 1 |
| What is the maximum hop count for Link-State protocols?
A.) 15
B.) there is no hop count limit
C.) 256
D.) 16 | | 1 |
| Identify 2 PPP characteristics?
A.) Is proprietary to Cisco
B.) Supports authentication
C.) Support compression
D.) Run on a multi-access network | | 1 |
| Identify the command mode necessary to enter the standard ping
command?
A.) Router(config)#
B.) Router>
C.) Router(std-ping)#
D.) Router(config-if)# | | 2 |
| Of the following switching types, which one has the lowest
latency?
A.) Cut-through
B.) Fragment Free
C.) None
D.) Store-and-forward | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
