| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| In regards to the OSI seven-layer model, at which layer is
EBCDIC
and ASCII?
A.) Presentation
B.) Application
C.) Transport
D.) Session
E.) Datalink
F.) Network | | 1 |
| WHAT IS DIFFERENCE BETWEEN FAST ETHERNET AND ETHERNET PORT? | Bank-Of-India | 4 |
| Which command will display the encapsulation type on interface
serial 0?
A.) show interface s0
B.) show all
C.) show int s0 encap
D.) show encap s0
E.) show encap | | 1 |
| Given the global configuration commands:
'banner motd #'
'Hello #'
When would the message be displayed?
A.) The message of the day banner shows up before login.
B.) The message of the day banner shows up during logoff.
C.) These commands are not the right syntax for MOTD.
D.) Message of the day banners are displayed upon entering
global config
mode.
E.) Message of the day banners are not possible.
F.) The message of the day would be, 'Hello #' | | 1 |
| Which of the following are valid WAN terms?
A.) DTE
B.) DCE
C.) Demarc
D.) CPE | | 1 |
| When you enter router passwords during the setup dialog what
is the difference between enable and the enable secret
passwords?
A. The enable password is encrypted
B. The enable secret password uses IPSec password authentication
C. The enable secret password cannot be seen as clear text
when viewing the configuration
D. The enable secret password acts as a backup in case the
enable password is compromised | Wipro | 6 |
| Which port numbers are used by TCP and UDP to set up
sessions with
other hosts?
A.) 1024 and above
B.) 6 and 17 respectively
C.) 1-25
D.) 6-17 | | 1 |
| You have just issued the erase startup-config Command and
reloaded your router. In which mode will your router be
when you react?
A. setup
B. startup
C. user EXEC
D. userd privileged
E. global configuration | | 1 |
| What parameter is used with statically assigned routers to tell
packets which interface to use to reach a distant network?
A.) Mask
B.) Subnet
C.) Default gateway
D.) Interface | | 1 |
| You are a system administrator on a NetWare network, you are
running NetWare 4.11 and you cannot communicate with your
router. What is the likely problem?
A. NetWare 4.11 defaults to 802.2 encapsulation.
B. NetWare 4.11 defaults to 802.3 encapsulation
C. Cisco routers only work with NetWare 3.11.
D. NetWare 3.11 defaults to 802.2 encapsulation. | | 1 |
| Which of the following protocols are used for logical network
addressing?
A.) IP
B.) TCP
C.) ARP
D.) ICMP
E.) RARP
F.) BootP | | 1 |
| Describe End to End network services: (Choose all that apply)
A.) Best Route selection
B.) Accomplished Segment by Segment, each segment is autonomous
C.) Flow Control & Data Integrity
D.) Best efforts packet delivery | | 1 |
| HOW MPLS IS DIFFERENT FROM OSPF? WHY NOW A DAYS MPLS IS
PREFERED OVER ANY NETWORK PROTOCOL? | Aricent | 1 |
| What is the protocol number for TCP?
A.) 80
B.) 21
C.) 11
D.) 6 | | 1 |
| Identify the IPX standard access-list number range?
A.) 600 - 699
B.) 1000 - 1099
C.) 1 - 99
D.) 100 - 199
E.) 800 - 899 | | 1 |
| Which protocol will send a message to routers if a network
outage or
congestion occurs?
A.) ARP
B.) TCP
C.) IP
D.) ICMP | | 1 |
| What is the protocol and what is the purpose of the
following address?
238 255 255 255
A. IPX a SAP broadcast
B. IP a multicast group
C. IP a reserved address
D. IP a directed broadcast
E. IPX a flooded broadcast | | 2 |
| How would you configure one host name that points to two IP
addresses?
A. IP host jacob 1.0.0.5 2.0.0.8
B. IP jacob 1.0.0.5 2.0.0.8
C. IP host jacob 1.0.0.5
D. IP host duplicate "all" | | 1 |
| Which OSI layer incorporates the MAC address and the LLC?
A.) Data link
B.) Network
C.) Physcial
D.) Transport | | 1 |
| Which type of switching is considered to be 'wire speed?'
A.) Cut-Through
B.) Multiplexed
C.) Inverted
D.) Layer 4
E.) Store and Forward
F.) Layer 3 | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
