What type of switching creates variable latency through the switch? A.)

Advertise your Business Here

Refer this Site

Login | Sign Up


	Do you have a collection of Interview Questions and interested to share with us!! Please send that collection to along with your userid / name. ThanQ

Categories >> Certifications >> Cisco Certifications >> CCNA

CCNA Interview Questions

CCDA Interview Questions

Question

What type of switching creates variable latency through the
switch?

A.) Cut-Through

B.) Inverted

C.) Layer 4

D.) Multiplexed

E.) Store and Forward

Question Submitted By :: Guest

I also faced this Question!!

Rank

Answer Posted By

Re: What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward

Answer
# 1

Answer: E

DEFINITION: Latency = Delay.

Because a store and forward switch reads the whole frame
before forwarding,

a larger frame takes longer than a shorter frame.

Is This Answer Correct ?

1 Yes

0 No

Guest

Question	Asked @	Answers
Other CCNA Interview Questions


what is the difference between switch and router??	Thomson	7
Can anyone explain the load balancing of PVST+????		1
A big part of the overhead on a network is broadcasts. You divide a large number of hosts into smaller individual networks and separate them with the proper device According to proper networking terminology you have created separate _______________________, User Domains Broadcast Domains Collision Areas Broadcast Areas		1
Identify the command that displays the SAP table? A.) show ipx servers B.) display SAP table C.) display SAP's D.) show sap table		1
What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS		2
What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM		1
Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map		1
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay		1
Identify the 2 commands that save the running-config to a TFTP server? A.) write running tftp B.) copy running network C.) copy running tftp D.) write network		1
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI		1
What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable		1
Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol		1
Given the following IP address from the Class B address range 172.35.21.12. Your network plan requires no more than 126 hosts on a shored. Which value should you use as the subnet mask? A. 255.255.0.0 B. 255.255.128.0 C. 255.255.126.0 D. 255.255.255.128 E. 255.255.255.252		3
Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises		1
Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252		1
what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain	IBM	5
Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises		1
IPX traffic using different encapsulation types can go over the same data link A. true B. false		1
An ISDN BRI circuit can be described as which of the following? A.) 3B channels B.) 2-64Kbps B channels and 1-16Kbps D channel C.) none of the above D.) 2-64Kbps B channels and 1-16Kbps C channel		1
Which type of switching reads in the entire frame before forwarding it? A.) Tabling B.) Store-and-Forward C.) Inverse ARP D.) Fast Forward E.) Cut-Through F.) Routing		1

For more CCNA Interview Questions Click Here


Copyright Policy \| Terms of Service \| Help \| Site Map 1 \| Articles \| Site Map \| Site Map \| Contact Us \|

Copyright © 2007 ALLInterview.com. All Rights Reserved.

ALLInterview.com :: Forum9.com :: KalAajKal.com