| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Identify the true statement regarding subnetting?
A.) Allows for more host address
B.) Borrow bits from the network portion of the address
C.) Allows for unlimited number of networks
D.) Borrow bits from the host portion of the address | | 1 |
| Identify the keystroke used to terminate the setup mode?
A.) Ctrl-K
B.) Crtl-C
C.) Ctrl-Z
D.) Crtl-End | | 1 |
| The Cisco Discovery Protocol (CDP) periodically sends out a
multicast packet (at layer 2). Which command will alter the
default
interval of 60 seconds?
A.) cdp hold 111
B.) cdp wait 111
C.) cdp interval 111
D.) cdp 111
E.) cdp timer 111 | | 1 |
| The Network layer works with which of the following:
A.) Globules
B.) Bits
C.) Packets
D.) Segments
E.) Frames | | 2 |
| what is telnet,ssh??
what is the perpose of this?
wer r this configured and how to configured?? | | 2 |
| What are the job opportunities i will get once i complete
my CCNA certification. | | 2 |
| What parameter is used with statically assigned routers to tell
packets
which interface to use to reach a distant network?
A.) Mask
B.) Subnet
C.) Default gateway
D.) Interface | | 1 |
| Identify 3 Fast Ethernet technologies?
A.) 100 Base FastEther
B.) 100 Base FX
C.) 100 Base T4
D.) 100 Base TX | | 1 |
| What is the protocol number for TCP?
A.) 80
B.) 21
C.) 11
D.) 6 | | 1 |
| What is masking? why is needed? | | 4 |
| What is the maximum hop count for IP RIP?
A.) Infinity
B.) 16
C.) 15
D.) 1 | | 1 |
| Which of the following are valid Cisco encapsulation type names?
A.) arpa = IPX Ethernet
B.) novell-ether = IPX Ethernet_802.3
C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring
D.) novell-fddi = IPX Fddi_Raw
E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring
F.) hdlc = HDLC on serial interfaces | | 1 |
| What does a Standard IP Access-list use as test criteria?
A.) IP source address
B.) IP source and destination address, protocol numbers and
port numbers
C.) IPX source and destination address
D.) Source MAC address | | 1 |
| MIDI and MPEG are examples of what layer of the OSI seven layer
model?
A.) Session
B.) Network
C.) Datalink
D.) Transport
E.) Application
F.) Presentation | | 4 |
| Identify the statement which connects access-list 101 inbound to
interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in | | 1 |
| What is a benefit of a virtual LAN (VLAN)?
A. It increases the number of broadcast domains
B. It decreases the number of broadcast domains
C. It increases the numberr of collision domains
D. It decreases the number of collision domains
E. Since it is a vitual Interface it never shuts down | | 3 |
| Identify the 2 rules used when configuring a Distance Vector
routing
protocol?
A.) Physically connected network(s)
B.) Configure the classfull address, no subnets
C.) Enable CDP so neighbors can be detected
D.) Same autonomous network | | 1 |
| Which layer defines the physical topology?
A.) Application
B.) Transport
C.) Network
D.) Data Link
E.) Physical
F.) Session | | 1 |
| What is true about Link-State protocols?
A.) They maintain a more complex table than distant vector
protocols
B.) They maintain a less complex table than distant vector
protocols
C.) They use routing ports
D.) The maintain backup copies of the IOS | | 1 |
| An ISDN BRI circuit can be described as which of the following?
A.) 3B channels
B.) 2-64Kbps B channels and 1-16Kbps D channel
C.) none of the above
D.) 2-64Kbps B channels and 1-16Kbps C channel | | 1 |
| |
| For more CCNA Interview Questions Click Here |