Which of the following are characteristics of UDP? A.) UDP is connection

Advertise your Business Here

Refer this Site

Login | Sign Up


	Ask Questions on ANYTHING, that arise in your Daily Life at FORUM9.COM

Categories >> Certifications >> Cisco Certifications >> CCNA

CCNA Interview Questions

CCDA Interview Questions

Question

Which of the following are characteristics of UDP?

A.) UDP is connection oriented.

B.) UDP is used with TFTP.

C.) UDP is unreliable.

D.) UDP is connectionless.

E.) UDP is at the transport layer.

F.) UDP uses no acknowledgements.

Question Submitted By :: Guest

I also faced this Question!!

Rank

Answer Posted By

Re: Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.

Answer
# 1

Answer: B C D E F

UDP sends packets 'blind' down the network, and relies on
upper-layer

protocols to form connections and detect errors. TCP is a

connection-oriented protocol that can provide reliable
transport.

Is This Answer Correct ?

3 Yes

0 No

Guest

Question	Asked @	Answers
Other CCNA Interview Questions


Which two statements about frame tagging are true? (Choose two) A. A filtering table is developed for each switch. B. Frame tagging assigns a unique user defined ID to each frame. C. A unique identifier is placed in the header of each frame as it is forwarded between switches. D. Frame tagging is a technique that examines particular information about each frame based on user defined offsets.		2
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full		1
Which processes does TCP, but not UDP, use? A. Windowing B. Acknowledgements C. Source Port D. Destination Port		1
What must be true for two Routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D)Configured for PPP	Allied-Group	1
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.		1
When configuring the subnet mask for an IP address, which formats can be used?A. dotted-decimal. B. Hexadecimal C. Bit-count D. Octal E. Binary		1
Identify 2 transport layer protocols? A.) IP B.) TCP C.) CDP D.) ARP E.) UDP		2
Identify the 2 commands that save the running-config to a TFTP server? A.) write running tftp B.) copy running network C.) copy running tftp D.) write network		1
What is the standard ISDN term for a non-native analog telephone? A.) TE1 B.) TA C.) LE D.) TE2 E.) ET		1
Identify the access-list range for an extended IP access-list? A.) 800 - 899 B.) 1 - 99 C.) 1000 - 1099 D.) 100 - 199		1
What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot		2
Identify 3 feature of access-lists? A.) Implicit deny will deny any packets not matched B.) Processed sequentially from bottom to top C.) Processed sequentially from top to bottom D.) If a packet is denied it would be tested against the remaining statements in the access-list E.) Once a match is made the packet is either denied or permitted F.) Enabled on all interfaces by default		1
Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network		2
In transport layer, for connection oriented communication Three way handshake process is there to establish a connection. So question is that, when a host send an ACK messages to another host with host intend to establish a connection, the source host send it as Broadcast or unicast message? Cud anyone explain this. Thanks in advance.	HCL	3
Novell NetWare has an Ethernet frame type called Ethernet_802.2. What is the matching Cisco command line keyword for this encapsulation method? A.) gns B.) arpa C.) snap D.) sap E.) novell-ether F.) dix		1
Which protocol will send a message to routers if a network outage or congestion occurs? A.) ARP B.) TCP C.) IP D.) ICMP		1
Select the fields for the Cisco HDLC protocol: A. Flag, Address, Control B. Flag, Address, Control, Protocol, LCP (Code, Identifier, Length, Data), FCS, Flag C. Flag, Address, Control, Data, FCS, Flag D. Flag, Address, Control, Proprietary, Data, FCS, Flag		1
What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network		1
Hi, Jitendra/Shahin You both are masters of networking na. I am worrying about my exam. Is it vey tough?because my friend got failed in ccna. he is very talented person thogh he failed.		1
What is SIA (Stuck in Active) in EIGRP?	Hathway	4

For more CCNA Interview Questions Click Here


Copyright Policy \| Terms of Service \| Help \| Site Map 1 \| Articles \| Site Map \| Site Map \| Contact Us \|

Copyright © 2007 ALLInterview.com. All Rights Reserved.

ALLInterview.com :: Forum9.com :: KalAajKal.com