| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which layer is responsible for negotiating data transfer syntax?
A.) Network
B.) Session
C.) Application
D.) Transport
E.) Presentation | | 2 |
| Identify the protocol to test connectivity without
configuring any
layer 3
protocols?
A.) TCP
B.) Ping
C.) IP
D.) CDP
E.) Telnet | | 1 |
| What type of frame does CDP use to gather information about it's
neighbors?
A.) TCP/IP
B.) Novell-ether
C.) Subnetwork Access Protocol (SNAP)
D.) Ethernet_II | | 1 |
| What is the extended IPX access list range?
A.) 901-1000
B.) 100-199
C.) 900-999
D.) 1000-1000 | | 1 |
| You create the following standard access-list
access-list 1 deny 1.1.1.1
access-list 1 deny 2.2.2.2
int e0
ip access-group 1 in
Which of the following statements are true, with regard to
traffic flowing
into E0?
A.) This will stop IP packets with a source address of
1.1.1.1 only.
B.) This will stop all IP packets.
C.) This is an invalid configuration.
D.) This will stop no IP packets.
E.) This will stop IP packets with a source address of
2.2.2.2 only.
F.) This will stop IP packets with a source address of
1.1.1.1 and 2.2.2.2. | | 1 |
| You have a Class B network address divided into 30 subnets. You
will add 25 new subnets within the next year. You need 600
host IDs for
each subnet.
Which subnet mask should you use?
A.) 255.254.0.0
B.) 255.192.0.0
C.) 255.255.252.0
D.) 255.255.248 0 | | 1 |
| Identify the definition of demarcation?
A.) Date in which the WAN service contract expires
B.) Cabling which extends from the WAN service provider to
the customer
C.) Division of responsibility, where the CPE ends and the
local loop
begins
D.) Equipment which is located at the customer premises | | 1 |
| Which of the following do not belong to the customer?
A.) CO
B.) DCE
C.) Router
D.) CPE
E.) Demarc
F.) DTE | | 1 |
| What does the following line for an access list do? 'access-list
101 deny tcp 3.4.5.0 0.0.0.255 any eq 23'
A.) deny all ftp traffic
B.) deny all ftp traffic from subnet 3.4.5.0
C.) deny all telnet traffic from subnet 3.4.5.0
D.) deny all ftp traffic to subnet 3.4.5.0
E.) deny all telnet traffic | | 1 |
| What is the result of segmenting a network with a router
into segments 1 and 2?
A. It increases the number of collisions
B. It decreases the number of broadcast domains
C. It connects segment 1 and broadcasts to segment 2
D. It connects segment 1 and broadcasts from genre to segment 2 | | 1 |
| Which port numbers are used by TCP and UDP to set up
sessions with
other
hosts?
A.) 1024 and above
B.) 6 and 17 respectively
C.) 1-25
D.) 6-17 | | 4 |
| What is the default LMI type?
A.) Cisco
B.) ANSI
C.) IETF
D.) Q933a | | 1 |
| When you use the Cisco IOS command show configuration on a
router which part of the output shows the specific conferred
IP addresses and shored masks?
A. the IP host table
B. the interfaces output
C. each section of the output
D. the global configuration statements
E. the section under the autonomous system number | | 1 |
| Inverse ARP serves what purpose?
A.) Method for a local router to introduce itself to the
remote end of the
connection
B.) Broadcast a routing table update
C.) Identify MAC addresses if the IP address is known
D.) Sent every 10 seconds used to verify the Frame Switch is
still active | | 1 |
| What does the acronym ARP stand for?
A.) Address Resolution Phase
B.) ARP Resolution Protocol
C.) Address Resolution Protocol
D.) Address Recall Protocol | | 2 |
| Identify 3 methods used to prevent routing loops?
A.) Split horizon
B.) Holddown timers
C.) Poison reverse
D.) SPF algorithm
E.) LSP's | | 1 |
| What is the routing metric used by IGRP?
A.) MTU, delay, bandwidth, reliability, and loading
B.) Count to infinity
C.) TTL
D.) Hop count | | 1 |
| Which layer is responsible for flow control,
acknowledgement, and
windowing?
A.) Transport
B.) Network
C.) Application
D.) Session
E.) Physical
F.) Data Link | | 1 |
| What is the command to start IP RIP version 1 routing on a
Cisco router?
A. show rip
B. enable rip
C. router enable
D. router rip | | 4 |
| What is difference between Store-and-Forward, cut-through,
Fragment-Free Method? | Microsoft | 2 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
