ALLInterview.com :: Home Page KalAajKal.com
 Advertise your Business Here     
Browse  |   Placement Papers  |   Company  |   Code Snippets  |   Certifications  |   Visa Questions
Post Question  |   Post Answer  |   My Panel  |   Search  |   Articles  |   Topics  |   ERRORS new
   Refer this Site  Refer This Site to Your Friends  Site Map  Bookmark this Site  Set it as your HomePage  Contact Us     Login  |  Sign Up                      
tip   To Refer this Site to Your Friends   Click Here
Google
 
Categories  >>  Certifications  >>  Cisco Certifications  >>  CCNA
 
 


 

 
 CCNA interview questions  CCNA Interview Questions
 CCDA interview questions  CCDA Interview Questions
Question
What is the default CDP broadcast update rate for Cisco routers?

A.) 120 seconds

B.) 60 seconds

C.) 30 seconds

D.) 90 seconds
 Question Submitted By :: Guest
I also faced this Question!!     Rank Answer Posted By  
 
  Re: What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds
Answer
# 1
Answer: B

Cisco Discovery Protocol is a proprietary protocol to allow
you to

access configuration information on other routers and
switches with a

single command. It uses SNAP at the Data-Link Layer. By
default CDP

sends out a broadcast every 60 seconds and it holds this
information for

180 seconds. CDP is enabled by default.
 
Is This Answer Correct ?    0 Yes 0 No
Guest
 

 
 
 
Other CCNA Interview Questions
 
  Question Asked @ Answers
 
Identify 3 feature of access-lists? A.) Implicit deny will deny any packets not matched B.) Processed sequentially from bottom to top C.) Processed sequentially from top to bottom D.) If a packet is denied it would be tested against the remaining statements in the access-list E.) Once a match is made the packet is either denied or permitted F.) Enabled on all interfaces by default  1
Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes  1
Identify 1 characteristic of RARP? A.) IP to MAC address translation B.) Connectionless delivery of packets C.) Can be used to initiate remote O/S load sequence D.) Generates error and control messages  1
Which command will display the encapsulation type on interface serial 0? A.) show interface s0 B.) show all C.) show int s0 encap D.) show encap s0 E.) show encap  1
Which three devices can be used to convert the user data from the DTE into a form acceptable to the WAN service's facility? A. Modem B. CSU/DSU C. TA/NT1 D. CO E. SS7  1
MIDI and MPEG are examples of what layer of the OSI seven layer model? A.) Session B.) Network C.) Datalink D.) Transport E.) Application F.) Presentation  1
The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC  1
Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24  1
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message  1
The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.  1
Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction  1
Which two statements about integrated services digital network (ISDN) are true? A. ISDN provides data only capability B. ISDN provides an integrated voice/data capability C. The ISDN standards define the hardware and call setup schemes for end the end digital connectivity D. Users receive more bandwidth on WANS with a leased lin of 56 Cops than with multiple B channels  1
Identify 2 features of PPP PAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) More secure than CHAP D.) Remote node is control of authentication process  1
Identify 3 methods used to prevent routing loops? A.) Split horizon B.) Holddown timers C.) Poison reverse D.) SPF algorithm E.) LSP's  1
What command would show the version of the IOS that you are running? A.) show nvram B.) show version C.) show startup-config D.) show ios E.) ver -a F.) show ram  1
Which of the following provide correct information about a protocol at the transport layer of the OSI model? A.) UDP - Provides Connectionless datagrams service B.) TCP - Provides Connection Oriented Services C.) SMTP - Provides Mail Exchange D.) IP - Route determination E.) TCP - Provides Flow Control and Error Checking F.) FTP - Transfers of Files  1
Which of the following describe SMTP? A.) Used for downloading files to the router. B.) Used for sending e-mail. C.) Uses TCP. D.) Uses UDP. E.) Uses port 25. F.) Used for managing IP devices.  1
CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection  2
What is the routing algorithm used by RIP and IGRP? A.) OSPF B.) Link-state C.) Dynamic D.) Distance Vector  2
Which fields of an IP packet provide for fragmentation of datagrams to allow differing MTUs in the internet? A. Identification B. Flags C. Frag Offset D. Type of Service E. Total Length  1
 
For more CCNA Interview Questions Click Here 
 
 
 
 
 
   
Copyright Policy  |  Terms of Service  |  Help  |  Site Map 1  |  Articles  |  Site Map  |   Site Map  |  Contact Us interview questions urls   External Links 
   
Copyright © 2007  ALLInterview.com.  All Rights Reserved.

ALLInterview.com   ::  Forum9.com   ::  KalAajKal.com