| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Identify the default values that make up IGRP's composite
metric?
A.) Bandwidth
B.) Load
C.) Reliability
D.) MTU
E.) Delay | | 1 |
| Which of the following provide correct information about a
protocol at the
transport layer of the OSI model?
A.) UDP - Provides Connectionless datagrams service
B.) TCP - Provides Connection Oriented Services
C.) SMTP - Provides Mail Exchange
D.) IP - Route determination
E.) TCP - Provides Flow Control and Error Checking
F.) FTP - Transfers of Files | | 1 |
| When you use the Cisco IOS command show configuration on a
router which part of the output shows the specific conferred
IP addresses and shored masks?
A. the IP host table
B. the interfaces output
C. each section of the output
D. the global configuration statements
E. the section under the autonomous system number | | 1 |
| Which layer is responsible for flow control,
acknowledgement, and
windowing?
A.) Transport
B.) Network
C.) Application
D.) Session
E.) Physical
F.) Data Link | | 2 |
| Which two encapsulation names are correctly paired with the
Cisco IOS encapsulation names? (Choose two)
A. Ethernet_II-ARPA
B. Ethernet_802.3-SAP
C. Ethernet_802.2-LLC
D. Ethernet_SNAP-SNAP | | 1 |
| Identify the keystroke to position the cursor to the
beginning of
a command line?
A.) Ctrl-A
B.) Ctrl-Ins
C.) Ctrl-B
D.) Ctrl-Z | | 1 |
| Identify 3 characteristics of IP RIP?
A.) Distance vector
B.) Administrative distance is 120
C.) Periodic updates every 60 seconds
D.) Uses a composite metric
E.) Can load balance | | 1 |
| Which command do you use to set the Secret password to
'roundwood'?
A.) enable login roundwood
B.) enable password roundwood
C.) enable privilege roundwood
D.) enable secret= roundwood
E.) enable secret login roundwood
F.) enable secret roundwood | | 1 |
| Whith the hierarchical numbering of IP addressing what
determines the spoon of the address that will identify the
network number?
A. subnet mask
B. dots between octets
C. class of the first octet
D. assignments of DHCP
E. address resolution process | | 1 |
| Which of the following is a characteristic of a switch, but
not of
a repeater?
A.) Switches forward packets based on the IPX or IP address
in the frame
B.) Switches forward packets based on the IP address in the
frame
C.) Switches forward packets based on the MAC address in the
frame
D.) Switches forward packets based only on the IP address in
the packet | | 2 |
| How many LMI types are available on Cisco routers?
A.) Four
B.) Two
C.) Five
D.) Three | | 1 |
| Which two statements are true? (Choose two)
A. Ethernet 802.3 utilizes a half duplex method for data
transfer
B. In a 100 MBS point to point connection a full duplex
connection can provide 400 Mbs of data transfer
C. Ethernet switches can use the full duplex mode to connect
multiple nodes on a single pod of a switch
D. Full duplex Ethernet takes advantage of UTP using one
pair for transmission and the other pair for reception | | 1 |
| What is the total bandwidth of all channels on a BRI circuit?
A. 56 kps
B. 64 kps
C. 112 kps
D. 128 kps
E. 144. kps | | 5 |
| Which of the following is a valid extended IP access-list?
A.) router(config)# access-list 101 permit tcp host
172.16.30.0 any eq
21 log
B.) router# access-list 101 permit tcp host 172.16.30.0 any
eq 21 log
C.) router(config)# access-list 101 permit any any 172.16.30.0
D.) router(config)# access-list 101 permit ip host
172.16.30.0 any eq 21
log | | 2 |
| As a system administrator, you perform an extended ping at
the privileged EXEC prompt. As part of the display, you see
"Set DF bit in IP header? [yes] :" What would happen if you
answered no at the prompt.
A. This lets the router fragment the packet.
B. It tells the router not to fragment the packet.
C. This lets the router direct the packet to the destination
it finds in its routing table.
D. It tell the router to send the packet to the next hop
router. | | 1 |
| How many total hosts are possible with a Class C address and
a subnet mask of 255.255.255.252?
A. 4
B. 30
C. 60
D. 62
E. 112
F. 124 | | 6 |
| What does the Spanning Tree Algorithm (STA) do?
A.) Restore lost frames
B.) Builds routing tables for routing through an internetwork
C.) Forward packets through a switch
D.) STA is implemented by STP to prevent loops | | 1 |
| Which command will show you if you have a DTE or DCE
cable connected to an interface? | | 3 |
| What is true about frame-relay DLCI?
A.) DLCI represents a single physical circuit
B.) DLCI is optional in all frame-relay networks
C.) DLCI identifies a logical connection between DTE devices
D.) DLCI is used to tag the beginning of a frame with VLAN
information | | 1 |
| Of the following characteristics, which apply to UDP?
Connection-oriented
Connectionless
Error checking
Low overhead
Best-effort delivery
| | 3 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
