| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| In regards to the ISDN BRI standard, which channel is used for
control?
A.) B
B.) D
C.) E
D.) I
E.) Q | | 2 |
| You are logged into a router, what command would
show you the IP addresses of routers connected to you?
A. show cdp neighbors detail
B. show run
C. show neighbors
D. show cdp | | 2 |
| Which of the following is an example of the Session Layer?
A.) TCP
B.) SQL
C.) IP
D.) X-Windows
E.) Token Ring
F.) LLC | | 2 |
| Identify the keystroke to position the cursor to the
beginning of
a command line?
A.) Ctrl-A
B.) Ctrl-Ins
C.) Ctrl-B
D.) Ctrl-Z | | 1 |
| What is the default encapsulation and frame type on an Ethernet
interface
when enabling Novell?
A.) SNAP
B.) Ethernet_II
C.) 802.2
D.) 802.3
E.) SAP
F.) Novell-ether | | 1 |
| Which protocol is used for booting diskless workstations?
A.) IP
B.) ARP
C.) RARP
D.) TCP
E.) SNMP | | 2 |
| Station A is transmitting data to station B, and expects an
acknowledgment after every 400 bytes. After transmitting
data for a
while, the two stations determine the line is reliable and
change to
expecting and acknowledgement every 600 bytes.
This is an example of (pick the best answer only):
A.) BECN
B.) Sliding Windows
C.) Poison Reverse
D.) Countdown timers
E.) Split Horizon
F.) Count to infinity | | 1 |
| You need to come up with a TCP/IP addressing scheme for your
company. Which two factors must you consider when you define
the subnet
mask for the network?
A.) The location of DHCP servers
B.) The volume of traffic on each subnet
C.) The number of subnets on the network
D.) The location of the default gateway
E.) The number of host IDs on each subnet | | 1 |
| Which of the following describe full-duplex transmission?
A.) Uses a single wire
B.) Data transmission in both directions, but only one way
at a time
C.) Uses a point-to-point connection from the transmitter of the
transmitting station to the receiver of the receiving station
D.) Data transmission in only one direction | | 2 |
| What are four benefits that can result from applying ISDN
networking? (Choose four)
A. Full time connectivity across the ISDN is spoofed by
Cisco IOS routers using dial on demand routing (DDR)
B. Small Once and Home Once sites can be economically
supported with ISDN Basic Rate Interface (BRI) servkps
C. ISDN replaces Signaling System 7 (SS7) in the Public
Switched Telephone Network (PSTIC) backbone
D. ISDN can be used as a backup service for a leased line
connection between the remote and central chaps
E. Modem racking and cabling can be eliminated by
integration of digital modem cards on Cisco IOS Network
Acess Servers (NAS) | | 2 |
| Identify the command that configures serial0 for PPP
encapsulation?
A.) Router(config)# encapsulation ppp
B.) Router(config-if)# encapsulation serial ppp
C.) Router(config-if)# encapsulation ppp
D.) Router# encapsulation ppp | | 1 |
| Which ISDN protocol prefix specifies switching and signaling?
A.) I
B.) E
C.) Q
D.) S | | 1 |
| Which three tasks are required to confound a dial on demand
routing (DDR) Basic Rate Interface (BRI) connection?
(Choose three)
A. define static routes
B. confound the abler information
C. specify the interesting franc that can enable the link
D. define a DDR password to exchange when the link comes up | | 1 |
| Which statement is true when a broadcast is sent in an
Ethernet/802.3 ITAN?
A. The ip shored used is 255.255.255.0
B. The IP address used is 255.255.255.255
C. The MAC address used is 00 00 00 00 00 00
D. The MAC address used is FF FF FF FF FF FF | | 1 |
| What is the purpose of ARP?
A.) IP to host name resolution
B.) Host name to IP address resolution
C.) Mac to IP address resolution
D.) IP to Mac address resolution | | 2 |
| Identify the OSI layer responsible for end-to-end connections?
A.) Network
B.) Transport
C.) Session
D.) Data link
E.) TCP | | 1 |
| Which statement about Ethernet switches is true?
A. Symmetric switching allows connection between pods of
unlike bandwidth and does not require memory buffering
B. Memory Buffering is used to prevent a bottleneck when
pods of different bandwidth are connected on a symmetric switch
C. The latency can be reduced if the switch utilizes the
store and forward method of switching store and forward is
better for error detection
D. The cut through method of switching is faster because the
switch forwards the packet to the destination as soon as it
reads the destination address | | 1 |
| The command "show IP protocol" displays which information?
A. routing timers
B. network information
C. contents of the IP routing table
D. information about all known network and subnetworks | | 2 |
| Which of the following is a layer 2 device?
A.) Switch
B.) Router
C.) Repeater
D.) Hub | | 3 |
| Given the global configuration commands:
'banner motd #'
'Hello #'
When would the message be displayed?
A.) The message of the day banner shows up before login.
B.) The message of the day banner shows up during logoff.
C.) These commands are not the right syntax for MOTD.
D.) Message of the day banners are displayed upon entering
global config
mode.
E.) Message of the day banners are not possible.
F.) The message of the day would be, 'Hello #' | | 1 |
| |
| For more CCNA Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
