Identify the default serial encapsulation?
A.) ISDN
B.) HDLC
C.) SDLC
D.) Frame Relay
E.) PPP
Answers were Sorted based on User's Feedback
Answer / guest
Answer: B
The default serial encapsulation is HDLC.
Is This Answer Correct ? | 12 Yes | 1 No |
What are the possible ways of data transmission in ccna?
what is telnet,ssh?? what is the perpose of this? wer r this configured and how to configured??
Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not at the same time
Which command will display Ethernet 0's IP address? A.) display ip address e0 B.) show ip interface e0 C.) show address e0 D.) sh ip address e0 E.) show all
Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?
Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a
What's the default CDP holdtime in seconds for Cisco routers? A.) 30 seconds B.) 180 seconds C.) 90 seconds D.) 60 seconds
Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory
Which addresses are INCORRECTLY paired with their class? A. 1 to 126, Class A B. 128 to 191, Class A C. 1 to 126, Class B D. 128 to 191, Class B
Explain the difference between baseband and broadband transmission in ccna?