| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Identify the 3 Internet layer IP protocols?
A.) NetBios
B.) IPX
C.) ARP
D.) IP
E.) RARP | | 1 |
| Identify 2 transport layer protocols?
A.) IP
B.) TCP
C.) CDP
D.) ARP
E.) UDP | | 1 |
| What is the bit length and expression form of a MAC address?
A. 24 bits expressed as a decimal number
B. 24 bits expressed as a hexadecimal number
C. 36 bits expressed as a binary number
D. 48 bits expressed as a decimal number
E. 48 bits expressed as a hexadecimal number | | 2 |
| Which OSI layer handles physical address, network topology?
A.) Presentation
B.) Physical
C.) Transport
D.) Application
E.) Data-Link
F.) Network | | 1 |
| Which term describes the process in which frames from one
network system are placed inside the frames of another
network system?
A. bridging
B. tunnelling
C. data link control
D. generic routing
E. packet switching | | 1 |
| Which statement is true regarding full duplex?
A.) Allows for transmission and receiving of data simultaneously
B.) Only works in a multipoint configuration
C.) Does not affect the bandwidth
D.) Allows for transmission and receiving of data but not a
the same time | | 1 |
| Identify the X.25 addressing standard?
A.) X.121
B.) X.25a
C.) ITU-1
D.) Q933a | | 1 |
| Identify 2 characteristics of PPP?
A.) Uses LLC to establish the link
B.) Default serial encapsulation
C.) Support multiple layer 3 protocols
D.) Offers two types of authentication; PAP and CHAP | | 2 |
| Which two steps are required to confound and apply standard
access lists on an interface? (Choose two)
A. define an access list number and its parameters
B. enable an interface to become part of the access list group
C. define the number of access lists to be supported on an
interface
D. copy the access list definition to each interface that
will support it | | 2 |
| Cisco routers can secure the enable password with a one-way hash
algorithm. What command would encrypt the enable password
with the
strong encryption method?
A.) enable encrypt john
B.) password john
C.) enable secret john
D.) enable password john
E.) secret john
F.) enable password 5 john | | 1 |
| Identify the command to configure the configuration-register?
A.) Router# config-register 0x2102
B.) Router(config)# config-register 0x2102
C.) Router(config-reg)# 0x2102
D.) Router> config-register 0x2102 | | 1 |
| What is a benefit of a virtual LAN (VLAN)?
A. It increases the number of broadcast domains
B. It decreases the number of broadcast domains
C. It increases the numberr of collision domains
D. It decreases the number of collision domains
E. Since it is a vitual Interface it never shuts down | | 2 |
| Which line from a show spantree 1 command output indicates
that virtual LAN 1 (VLAN1) is functioning properly?
A. Root pod is FastEthernet 0/26
B. Port Ethernet 0/1 of VLAN1 is Forwarding
C. Designated port is Ethernet 0/1, path cost 10
D. Designated root has priority 0 address 00D0 588F B600
E. VLAN1 is executing the IEEE compatible Spanning Tree Protocol | | 1 |
| Which type of switching reads just the address portion of the
frame and then immediately starts forwarding it?
A.) Cut-Through
B.) Store-and-Forward
C.) Tabling
D.) Routing
E.) Inverse ARP
F.) Fast Forward | | 1 |
| What's the default CDP holdtime in seconds for Cisco routers?
A.) 30 seconds
B.) 180 seconds
C.) 90 seconds
D.) 60 seconds | | 1 |
| Which feature of PPP (Point to Point Protocol) allows the router
to bind multiple channels together, to form a single logical
channel?
A.) multi-link ppp
B.) multi-channel ppp
C.) can't be done
D.) omni-ppp
E.) plp | | 1 |
| Which layer is responsible for determining if sufficient
resources
for the intended communication exists?
A.) Application
B.) Network
C.) Session
D.) Presentation
E.) Transport | | 1 |
| Which of the following is an example of the Network Layer?
A.) TCP
B.) IP
C.) SQL
D.) Token Ring
E.) LLC | | 1 |
| What does 'P' mean when running a Trace?
A.) Good route
B.) Protocol unreachable
C.) Source Quench
D.) Destination unreachable | | 1 |
| Which of the following are valid WAN terms?
A.) DTE
B.) DCE
C.) Demarc
D.) CPE | | 1 |
| |
| For more CCNA Interview Questions Click Here |
along with your userid / name. ThanQ
Site Map
