| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| Which symbol in the router prompt indicates you are in the
privelaged mode?
A. >
B. !
C. #
D. : | | 3 |
| What command can you type to view the connections after
telneting
into multiple routers simultaneously?
A.) sh users
B.) sh ports
C.) sh host
D.) sh sessions | | 1 |
| There is an emergency fall-back 'skeleton' IOS stored in
read only
memory on all Cisco routers. What command would make the
router load the
IOS from
Read Only Memory?
A.) reload rom
B.) boot system rom
C.) load ios bootflash
D.) load ios rom
E.) bootsystem skeleton | | 2 |
| What key do you use to view the last command?
A.) Ctrl+X
B.) Ctrl+Z
C.) Ctrl+E
D.) Ctrl+P | | 2 |
| Identify the command that configures serial0 for PPP
encapsulation?
A.) Router(config)# encapsulation ppp
B.) Router(config-if)# encapsulation serial ppp
C.) Router(config-if)# encapsulation ppp
D.) Router# encapsulation ppp | | 1 |
| Which layer is responsible for coordinating communication
between
systems?
A.) Application
B.) Network
C.) Session
D.) Transport
E.) Physical
F.) Data Link | HCL | 2 |
| Which ISDN protocol prefix specifies switching and signalling?
A.) I
B.) E
C.) Q
D.) S | | 1 |
| Extended IP access-lists (100-199) can be used to control
traffic.
Which command listed below will permit smtp mail to only
host 3.4.5.6 ?
A.) It is not possible for SMTP traffic
B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp
C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23
D.) access-list 102 permit tcp any any eq smtp
E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25 | | 1 |
| Define Poison Reverse?
A.) To prevent regular update messages from reinstating a
route that has
gone down
B.) Packets sent out that are not destined for a network go
to the
default network
C.) Information received on an interface cannot be sent back
out the
same interface
D.) When a network goes down, the router enters in its table
the number
16 to signify destination unreachable | Google | 1 |
| If configuring a Cisco router to connect to a non-Cisco router
across a
Frame Relay network, which encapsulation type would you select?
A.) Q933a
B.) ISDN
C.) IETF
D.) CISCO
E.) ANSI | | 1 |
| what is bgp, and what its attributes (thanks to sahin he
sende me notes)
Please try to give answer it will help you in future. after
giving the answer most of them i am selected foro\ 2nd round
of interview
thanks | IBM | 1 |
| What does the User Datagram Protocol (UDP) provide?
A.) Connectionless datagram service.
B.) FECN & BECN
C.) Flow control and error checking.
D.) Name resolution.
E.) Path discovery. | | 1 |
| Which OSI layer supports the communication component of an
application?
A.) Data-Link
B.) Physical
C.) Session
D.) Presentation
E.) Application
F.) Transport | | 2 |
| The Cisco IOS is stored where?
A.) ROM
B.) CD
C.) Flash
D.) NVRAM | | 1 |
| 2. What are the valid ways to segment a LAN? (Choose all
that apply)
A. Repeater
B. Bridge
C. Switch
D. Router
| | 2 |
| Which of the following statements are true?
A.) Store and forward switching creates variable latency
through the switch
B.) Cut through switching creates variables latency through
the switch
C.) Cut through switching works at wire speed
D.) Store and forward switching works at wire speed | | 1 |
| What is the default LMI type?
A.) Cisco
B.) ANSI
C.) IETF
D.) Q933a | | 2 |
| what is native vlan
any one explain
sooraj | | 2 |
| A traffic light is an example of what type of mechanism?
A.) Collision detection
B.) Flow control
C.) Sequence numbering
D.) Network management | | 1 |
| What do the following commands accomplish?
access-list 1 deny 172.16.4.0 0.0.0.255
access-list 1 permit any
interface ethernet 0
IP access-group 1 out
A. This will block traffic from subnet 172.16.4.0 and allow
all other
traffic.
B. This will allow traffic from subnet 172.16.4.0 and block
all other
traffic.
C. All traffic is allowed.
D. All traffic is blocked. | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
