| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| What are the two components of an IPX address?
A. network number IP address
B. MAC address node number
C. network number MAC address
D. network number arched number | | 1 |
| Of the following characteristics, which apply to UDP?
Connection-oriented
Connectionless
Error checking
Low overhead
Best-effort delivery
| | 3 |
| A router blocks ___________
Broadcasts
Unicasts
All packets
Nothing
| | 1 |
| What command can be used to test IPX connectivity?
A.) Ping 2e.000.0045.8923
B.) Ping 192.168.100.1
C.) Ping ipx 2e.0000.0045.8923
D.) Ipx ping 2e.0000.0045.8923 | | 3 |
| Which network mask should you place on a Class C address to
accommodate a user requirement for five networks with a
maximum of 17 hosts on each networks
A. 255.255.255.192
B. 255.255.255.224
C. 255.255.255.240
D. 255.255.255.248 | | 7 |
| Station A is transmitting data to station B faster that
station B
can handle it. When station B's buffer fills up, it send out
a message
to station A to stop sending data. After B empties out its
buffer,
station B sends a message to station A to start sending data
again.
This is most directly an example of (pick the best answer only):
A.) Poison Reverse
B.) Connectionless protocol
C.) Windowing
D.) Connection oriented protocol
E.) Flow Control
F.) Split Horizon | | 1 |
| What is difference between standard and extended access-list | HCL | 8 |
| What is the maximum hop count for Link-State protocols?
A.) 15
B.) there is no hop count limit
C.) 256
D.) 16 | | 1 |
| When you enter router passwords during the setup dialog what
is the difference between enable and the enable secret
passwords?
A. The enable password is encrypted
B. The enable secret password uses IPSec password authentication
C. The enable secret password cannot be seen as clear text
when viewing the configuration
D. The enable secret password acts as a backup in case the
enable password is compromised | Wipro | 6 |
| How do i decide if an extended access-list is in or out?
| | 1 |
| what is vc,pvc,lmi and dlsi | | 1 |
| You have two Cisco routers setup back-to-back in a lab using
DTE/DCE cables. To which router would you add the clockrate
command?
A.) The serial port on the DCE router
B.) The Ethernet port on the DTE router
C.) The Ethernet port on the DCE router
D.) The serial port on the DTE router | TCS | 3 |
| HOW MPLS IS DIFFERENT FROM OSPF? WHY NOW A DAYS MPLS IS
PREFERED OVER ANY NETWORK PROTOCOL? | Aricent | 2 |
| What is the command to copy the IOS image to a TFTP server?
A.) copy flash tftp
B.) copy running-config tftp
C.) copy ios tftp
D.) copy startup-config tftp | | 2 |
| What does the command show access-lists 101 list?
A. all defended access lists
B. all access lists within the router
C. the contents of standard access list 101
D. the contents of defended access list 101 | | 1 |
| Identify the switching method that examines the destination MAC
address as
the frame is being received then begins forwarding the frame
prior to
receiving the entire frame?
A.) Fragment-free
B.) Store and Forward
C.) Cut-through
D.) Fast forward | | 1 |
| Which of the following do not belong to the customer?
A.) CO
B.) DCE
C.) Router
D.) CPE
E.) Demarc
F.) DTE | | 1 |
| Which three tasks are required to confound a dial on demand
routing (DDR) Basic Rate Interface (BRI) connection?
(Choose three)
A. define static routes
B. confound the abler information
C. specify the interesting franc that can enable the link
D. define a DDR password to exchange when the link comes up | | 1 |
| What is the Broadcast MAC Address? | Avaya | 2 |
| Which OSI layer defines end to end communication,
segmentation and
re-assembly?
A.) Network
B.) Transport
C.) Physical
D.) Application
E.) Data-Link
F.) Presentation | | 1 |
| |
| For more CCNA Interview Questions Click Here |
Site Map
