| Other CCNA Interview Questions |
| |
| Question | Asked @ | Answers |
| |
| The following selections show the command prompt and the
configuration of the IP network mask. Which two are
correct?
A. Router#term IP netmask-format { bitcount | decimal |
hexadecimal }
B. Router(config-if)#IP netmask-format { bitcount | decimal
| hexadecimal }
C. Router(config-if)#netmask-format { bitcount | decimal |
hexadecimal }
D. Router#ip netmask-format { bitcount | decimal | hexadecimal } | | 1 |
| What does the IPX maximum-path command do?
A.) Allows you to disable the TTL on an IPX packet
B.) This parameter is only used in NLSP routing
C.) Sets the maximum metric that can appear in the routing table
D.) Configures round robin load sharing over multiple equal
metric paths
(parallel paths) | | 1 |
| How can an Ethernet switch improve network performance?
Choose three | | 1 |
| Which command should you use to create an IP standard access
list?
A. access-list standard 172.16.4.13
B. access-list 1 deny 172.16.4.13 0.0.0.0
C. access-list 100 deny 172.16.4.13 0.0.0.0
D. access-list 198 deny 172.16.4.13 255.255.255.255 | | 2 |
| 'Show cdp neighbors detail' show the following 3 pieces of
information?
A.) Hardware platform
B.) Software version
C.) Same as 'show version' command
D.) Up to 1 address for each protocol
E.) Non-direct connected routers | | 1 |
| what is unike ip address | | 1 |
| What is the command to allow you to type Tokyo instead of the IP
address 172.16.30.1 to access a router named Tokyo?
A.) config t, ip host Tokyo 172.16.30.1
B.) config t, ip hostname Tokyo 172.16.30.1
C.) config t, hostname Tokyo 172.16.30.1
D.) config t, ip hostname 172.16.30.1 Tokyo | | 1 |
| Identify the statement which connects access-list 101 inbound to
interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in | | 1 |
| What do the following commands accomplish?
access-list 1 deny 172.16.4.0 0.0.0.255
access-list 1 permit any
interface ethernet 0
IP access-group 1 out
A. This will block traffic from subnet 172.16.4.0 and allow
all other
traffic.
B. This will allow traffic from subnet 172.16.4.0 and block
all other
traffic.
C. All traffic is allowed.
D. All traffic is blocked. | | 1 |
| PLACE YOURS QUESTION HERE I ALSWYS BE HERE FROM 9 AM TO 6PM SO
U CAN FIND YOUR ANSWER QUICKLY.IF I KNOW THEN ?
JJIITTEENNDDEERRAA SSIINNHHAA | | 4 |
| Which of the following are solutions to the problems encountered
with Distance-Vector routing?
A.) Defining a Maximum
B.) Poison Reverse
C.) Triggered Updates
D.) Shortest path first algorithm.
E.) Split Horizon | | 1 |
| What is difference between IPv4 & IPv6?? | Hathway | 3 |
| Which statement is true?
A. While bridges are used to segment networks, they will not
isolate broadcast or multicast packets.
B. A bridge looks at every packet within its network segment
and works like a hub re-broadcasting the packet if the
destination is within its network segment.
C. A bridge maintains a table of the IP addresses of the
hosts within its network segment and forwards the packet
directly to the destination based upon the IP address.
D. A bridge resets the hop count by keeping all packets
within the network segment. Only packets addressed to a
specific destination host outside the network segment are
allowed to pass through the bridge. | | 1 |
| Which statement about the Point to Point Protocol (PPP) is true?
A. PPP supports TCP/IP but not Novell IPX
B. PPP is being phased out of existence by the Serial Line
Internet Protocol (SLIP)
C. PPP providces router to router and host to network
connections over both synchronous and asynchronous circuits
D. PPP is an ITU T and ANSI standard that defines the
process for sending data over a packet switched data network
(PSDN) | | 1 |
| Sequence and acknowledgement numbers are used for?
A.) Layer transitioning
B.) Flow control
C.) Port number addressing
D.) Reliability | | 1 |
| the situation iz like ths -at a specific time in our company
the internet connectivity goes off...v hav two networks in
our company...but out of it only one link goes down for 5-10
sec...a fastethernet port becomes down for few sec and
automatically becomes Up...
Is this occures becoz of Power??
If yes thn y the 2nd network is not affected?? | SoftTech | 1 |
| Which two statements about a bridge are true? (Choose two)
A. A bridge floods multicasts
B. A bridge floods broadcasts
C. A bridge does not flood multicasts
D. A bridge does not flood broadcasts | | 1 |
| What are the three phases of PPP session establishment?
A. Link establishment phase
B. Authentication phase
C. Network layer protocol phase
D. Handshake phase
E. Dial-in phase | | 2 |
| You have powered on a new router and you want to create an
initial configuration. Which mode should you use?
A. copy mode
B. user mode
C. setup mode
D. startup mode | Enrich | 3 |
| When you enter router passwords during the setup dialog what
is the difference between enable and the enable secret
passwords?
A. The enable password is encrypted
B. The enable secret password uses IPSec password authentication
C. The enable secret password cannot be seen as clear text
when viewing the configuration
D. The enable secret password acts as a backup in case the
enable password is compromised | Wipro | 6 |
| |
| For more CCNA Interview Questions Click Here |
Ask Questions on ANYTHING, that arise in your Daily Life at 
Site Map
